Related Experiment Video
Updated: Jun 25, 2026

Soft Lithographic Functionalization and Patterning Oxide-free Silicon and Germanium
Published on: December 16, 2011
Bioactive Properties of Phosphate-Modified Silicon Oxycarbide Protective Coatings: Morphology and Functional
Magdalena Gawęda1, Jakub Marchewka2, Piotr Jeleń2
1NOMATEN CoE, NOMATEN MAB, National Centre for Nuclear Research, A. Soltana 7 Str., 05-400 Otwock, Poland.
Abstract:
This article presents a study on the functional properties and morphology of coatings based on amorphous silicon oxycarbide modified with phosphate ions and comodified with aluminum and boron. The objective of this modification was to enhance the biocompatibility and bioactivity without affecting its protective properties. The comodification was aimed toward stabilization of phosphate in the structure. The coatings were prepared according to the typical procedure for polymer-derived ceramics: synthesized via the sol-gel method, deposited using the dip-coating technique, and subsequently pyrolyzed. Comprehensive analyses of the morphology, surface properties, corrosion resistance, and bioactivity were conducted to assess their functional performance. The coatings exhibited uniform and smooth surfaces, with phase separation observed in the boron-modified SiBPOC series. Surface wettability and free energy measurements demonstrated that SiPOC and SiBPOC coatings possessed moderate hydrophilicity and favorable surface free energy for cell adhesion and bone tissue mineralization. Corrosion resistance tests in Ringer's solution revealed that SiBPOC coatings provided the highest protection against ion leaching, while SiAlPOC showed decreased resistance due to surface cracks. Bioactivity tests indicated calcium phosphate precipitation on the surface of all samples with higher hydroxyapatite formation on SiPOC and SiAlPOC coatings. In vitro tests using MG-63 osteoblast-like cells confirmed the biocompatibility of the coatings, with SiPOC and SiBPOC exhibiting the best combination of bioactivity, cell adhesion, and proliferation. These findings suggest that the phosphate- and boron-modified SiOC-based coatings are promising candidates for enhancing bone integration in orthopedic implants.
Related Concept Videos
Carbon Skeletons
Protecting Groups for Aldehydes and Ketones: Introduction
Bicarbonate-Carbonic Acid Buffer
Carbonation Shrinkage
The concrete's permeability is slightly reduced as calcium carbonate produced during the reaction fills its pores. Furthermore, its strength is slightly enhanced as the water released during the reaction facilitates the...
Acid Attack on Concrete
The rate at which hydrogen...
Microbial Bioremediation of Pesticides

