Related Experiment Video
Updated: Jun 5, 2025

Methane Hydrate Crystallization on Sessile Water Droplets
Published on: May 26, 2021
Methane Hydrate-in-Oil Systems in the Presence of Natural Amino Acid-Equilibrium Phase Condition Measurements
Abdulrab Abdulwahab Almashwali1,2, Bhajan Lal1,2, Siak Foo Khor1,2
1Chemical Engineering Department, Universiti Teknologi PETRONAS, Bandar Seri Iskandar, Perak 32610, Malaysia.
Abstract:
This experimental study reports the thermodynamic influence of three different amino acids on methane hydrate in oil-dominated systems, namely, glycine, proline, and alanine. To thoroughly examine the effect of selected amino acids on methane (CH4) hydrate formation compared to the commercial inhibitor monoethylene glycol (MEG) in the presence of oil, the hydrate liquid-vapor equilibrium (H-Lw-Lo-V) curve is used to measure amino acid aqueous solutions. All experiments are performed at a concentration of 10 wt % by using the isochoric T-cycle technique in a high-pressure reactor cell at the selected range of pressures with temperatures of 4.0-9.0 MPa and 276.5-286.0 K, respectively. Results show that all studied amino acids inhibit hydrate formation of methane; the inhibition trend shows as glycine > alanine > proline in both systems; in the brine water system, the inhibition performance was higher than in the pure water system due to the presence of NaCl. Glycine showed the highest inhibition strength in both systems with an average reduced temperature in pure and brine water of 0.92 and 1.75 K, respectively, at 10 wt %, making the inhibition performance of glycine comparable to the commercial inhibitor MEG. The inhibition effect is attributed to the amino acid's hydrogen bonding energies and side group alkyl chain. Calculating the dissociation enthalpies of methane hydrates in the presence of amino acids using the Clausius-Clapeyron equation implies that the amino acids do not occupy the cage structures during methane hydrate formation.
Related Concept Videos
Titration of a Weak Base with a Strong Acid
Using the ICE table and substituting the Kb value, we calculate the initial pH of 50 mL of 0.1 M ammonia to be 11.11. Addition of 25 mL of 0.1 M hydrochloric acid to this solution of ammonia results in a buffer with an equal concentration of ammonia and ammonium ions. The pH of this buffer can be calculated by substituting these...
Inductive Effects on Chemical Shift: Overview
NMR Spectroscopy Of Amines
Weak Base Solutions
Leveling Effect and Non-Aqueous Acid-Base Solutions
The Leveling Effect of a Solvent
A generic acid (HA) reacts with the generic base (B-) to yield the corresponding conjugate base (A-) and conjugate acid (HB):
Position of Equilibrium in Acid-Base Reactions

