Related Experiment Video
Updated: Jun 5, 2025

Rapid Point-of-Care Assay of Enoxaparin Anticoagulant Efficacy in Whole Blood
Published on: October 12, 2012
Time as a significant factor in the release of potassium from lithium heparin plasma and serum
Tom Reuter1,2, Michael Müller2,3, Felix Stelter2,4
1LADR Laboratory Group Dr. Kramer & Kollegen, Geesthacht, Germany.
Objectives:
In most countries the majority of patients are in outpatient care. In difference to hospitalized patients, their blood samples often take hours after collection to centrifugation. The study investigates the release of potassium and the development of pseudohyperkalemia in lithium heparin (Li-Hep) and serum blood collection tubes over time.
Methods:
From 201 donors 4 serum and 4 Li-Hep blood collection tubes were taken each. After 0.5, 4, 6 and 8h whole blood was centrifuged, and potassium levels were determined. To simulate the preanalytic conditions, the samples with a storage time >0.5h were shaken on a standard shaker for 1h and stored at 4-8°C for the remaining time.
Results:
Over time, significant more potassium was released before centrifugation from the Li-Hep plasma than from serum (1.21 vs 0.94 mmol/L). After 6h, the two groups were no longer highly statistically significantly different (potassium mean: 5.01 mmol/L in serum group, 4.92 mmol/L in Li-Hep group). In the Li-Hep group 164 donors developed a pseudohyperkalemia after 8h, compared to 76 in the serum group.
Significance:
The decision as to which material is best suited should not only be based on which value comes closest to the physiological situation immediately after blood collection. The subsequent preanalytic circumstances must also be considered. Serum tubes appear to be at least as suitable for potassium determination as Li-Hep tubes. In terms of patient blood management, serum provides the possibility of performing a wider range of analyses in the outpatient setting.
More Related Videos
07:38Functional Characterization of Na+/H+ Exchangers of Intracellular Compartments Using Proton-killing Selection to Express Them at the Plasma Membrane
Published on: March 30, 2015
10:07High-throughput Screening for Small-molecule Modulators of Inward Rectifier Potassium Channels
Published on: January 27, 2013
Related Concept Videos
Nonlinear Pharmacokinetics: Drug Elimination for IV Bolus Injection
Following the administration of a single intravenous (IV) bolus injection, we can determine the concentration of the drug in the plasma at any given time. This calculation is achieved using a specific equation that integrates the values of Vmax and KM.
We can also...
One-Compartment Open Model for IV Bolus Administration: Estimation of Elimination Rate Constant, Half-Life and Volume of Distribution
Drug Concentration Versus Time Correlation
Two pivotal parameters are the minimum effective concentration (MEC) and the minimum toxic concentration (MTC). The MEC is the...
Determination of Michaelis Constant and Maximum Elimination Rate
These parameters can be estimated by analyzing plasma concentration data post-drug administration. A notable example of this application is phenytoin, a drug with capacity-limited kinetics. It's recommended that phenytoin should be administered at two...
Two-Compartment Open Model: IV Bolus Administration
The disparity between drug input and the sum of drug transfer rates between...
Depolarizing Blockers: Pharmocokinetics