On GEE for Mean-Variance-Correlation Models: Variance Estimation and Model Selection

Zhenyu Xu1, Jason P Fine2, Wenling Song3

  • 1Department of Statistics, University of Connecticut, Storrs, Connecticut.

Statistics in Medicine
|December 12, 2024
PubMed

Related Concept Videos

Variance01:15

Variance

 The deviations show how spread out the data are about the mean. A positive deviation occurs when the data value exceeds the mean, whereas a negative deviation occurs when the data value is less than the mean. If the deviations are added, the sum is always zero. So one cannot simply add the deviations to get the data spread. By squaring the deviations, the numbers are made positive; thus, their sum will also be positive.
The standard deviation measures the spread in the same units as the...
9.3K
Estimating Population Mean with Known Standard Deviation01:16

Estimating Population Mean with Known Standard Deviation

To construct a confidence interval for a single unknown population mean μ, where the population standard deviation is known, we need sample mean as an estimate for μ and we need the margin of error. Here, the margin of error (EBM) is called the error bound for a population mean (abbreviated EBM). The sample mean is the point estimate of the unknown population mean μ.
The confidence interval estimate will have the form as follows:
(point estimate - error bound, point estimate +...
8.3K
Estimating Population Mean with Unknown Standard Deviation01:22

Estimating Population Mean with Unknown Standard Deviation

In practice, we rarely know the population standard deviation. In the past, when the sample size was large, this did not present a problem to statisticians. They used the sample standard deviation s as an estimate for σ and proceeded as before to calculate a confidence interval with close enough results. However, statisticians ran into problems when the sample size was small. A small sample size caused inaccuracies in the confidence interval.
William S. Gosset (1876–1937) of the...
7.6K
Correlation and Regression00:53

Correlation and Regression

In statistics, correlation describes the degree of association between two variables. In the subfield of linear regression, correlation is mathematically expressed by the correlation coefficient, which describes the strength and direction of the relationship between two variables. The coefficient is symbolically represented by 'r' and ranges from -1 to +1. A positive value indicates a positive correlation where the two variables move in the same direction. A negative value suggests a...
1.2K
Empirical Method to Interpret Standard Deviation01:09

Empirical Method to Interpret Standard Deviation

The empirical rule, also known as the three-sigma rule, allows a statistician to interpret the standard deviation in a normally distributed dataset. The rule states that 68% of the data lies within one standard deviation from the mean, 95% lies within two standard deviations from the mean, and 99.7% lies within three standard deviations from the mean. Additionally, this rule is also called the 68-95-99.7 rule.
This rule is used widely in statistics to calculate the proportion of data values...
5.1K
Variation01:19

Variation

An important characteristic of any set of data is the variation in the data. In some data sets, the data values are concentrated closely near the mean; in other data sets, the data values are more widely spread out from the mean. The most common measure of variation, or spread, is the standard deviation, which is the square root of variance.
When independent and dependent variables are plotted on a scatter plot, the slope of a line is a value that describes the rate of change between the two...
6.7K