Jove
Visualize
Contact Us
JoVE
x logofacebook logolinkedin logoyoutube logo
ABOUT JoVE
OverviewLeadershipBlogJoVE Help Center
AUTHORS
Publishing ProcessEditorial BoardScope & PoliciesPeer ReviewFAQSubmit
LIBRARIANS
TestimonialsSubscriptionsAccessResourcesLibrary Advisory BoardFAQ
RESEARCH
JoVE JournalMethods CollectionsJoVE Encyclopedia of ExperimentsArchive
EDUCATION
JoVE CoreJoVE BusinessJoVE Science EducationJoVE Lab ManualFaculty Resource CenterFaculty Site
Terms & Conditions of Use
Privacy Policy
Policies

Related Concept Videos

Mass Analyzers: Common Types01:19

Mass Analyzers: Common Types

The quadrupole mass analyzer consists of four cylindrical metal rods arranged in a diamond carrying a DC voltage and a radio-frequency AC voltage. The motion of ions through the quadrupole depends on the field strength, causing only ions of a certain m/z to resonate successfully and strike the detector at a given field strength. Though the transmission rate for these analyzers is high, the exact elemental composition of the sample is not determined because of low resolution; however, they are...
Electronic Distance Measuring Instruments01:30

Electronic Distance Measuring Instruments

Electronic Distance Measuring Instruments (EDMs) are essential tools in modern surveying, offering precise distance measurements by emitting electromagnetic signals and calculating the time required for these signals to travel to a target and return. Two primary types of signals are used in EDMs — light waves and microwaves — each suited to specific environmental and distance requirements. Light-wave-based EDMs utilize either infrared or laser light, providing high accuracy over short distances...

You might also read

Related Articles

Articles linked to this work by shared authors, journal, and citation graph.

Sort by
Same author

Thermal Noise Measurement below the Standard Quantum Limit.

Physical review letters·2026
Same author

2025 Topical Meeting on Optical Interference Coatings: introduction.

Applied optics·2026
Same author

Ion-beam-sputtered mid-infrared coatings for hybrid supermirrors.

Applied optics·2026
Same author

Author Correction: Mid-infrared supermirrors with finesse exceeding 400 000.

Nature communications·2024
Same author

Surpassing the Standard Quantum Limit Using an Optical Spring.

Physical review letters·2024
Same author

Towards space-deployable laser stabilization systems based on vibration-insensitive cubic cavities with crystalline coatings.

Optics express·2024
Same journal

Gaussian-modulated continuous-variable quantum key distribution over 60 km fiber using an integrated silicon photonic receiver.

Optics letters·2026
Same journal

E2E-OCT: end-to-end joint learning model using optical coherence tomography images for vocal cord leukoplakia diagnosis.

Optics letters·2026
Same journal

Holographic generation of panoramic 3D scenes by concave ellipsoidal mirror reflection.

Optics letters·2026
Same journal

Dual-pilot phase recovery with pair-wise maximum-ratio combining for coherent PONs.

Optics letters·2026
Same journal

Mapping the whispering gallery modes of a CaF<sub>2</sub> disk resonator with half-tapered fibers to estimate the fundamental mode volume.

Optics letters·2026
Same journal

Quantitative estimation of deep-subwavelength scale via dark-field scattering axial energy concentration decay profiles.

Optics letters·2026
See all related articles

Related Experiment Video

Updated: May 17, 2026

The Generation of Higher-order Laguerre-Gauss Optical Beams for High-precision Interferometry
12:14

The Generation of Higher-order Laguerre-Gauss Optical Beams for High-precision Interferometry

Published on: August 12, 2013

21.7K

Optical spring tracking for enhancing quantum-limited interferometers.

Scott Aronson, Ronald Pagano, Torrey Cullen

    Optics Letters
    |December 13, 2024
    PubMed
    Summary
    This summary is machine-generated.

    Researchers dynamically tracked signals in interferometers, boosting signal-to-noise ratio (SNR) by 40x. This method overcomes limitations of static systems for detecting gravitational waves and other transient phenomena.

    More Related Videos

    Implementation of a Reference Interferometer for Nanodetection
    16:11

    Implementation of a Reference Interferometer for Nanodetection

    Published on: April 26, 2014

    9.3K
    Quantum State Engineering of Light with Continuous-wave Optical Parametric Oscillators
    09:23

    Quantum State Engineering of Light with Continuous-wave Optical Parametric Oscillators

    Published on: May 30, 2014

    14.4K

    Related Experiment Videos

    Last Updated: May 17, 2026

    The Generation of Higher-order Laguerre-Gauss Optical Beams for High-precision Interferometry
    12:14

    The Generation of Higher-order Laguerre-Gauss Optical Beams for High-precision Interferometry

    Published on: August 12, 2013

    21.7K
    Implementation of a Reference Interferometer for Nanodetection
    16:11

    Implementation of a Reference Interferometer for Nanodetection

    Published on: April 26, 2014

    9.3K
    Quantum State Engineering of Light with Continuous-wave Optical Parametric Oscillators
    09:23

    Quantum State Engineering of Light with Continuous-wave Optical Parametric Oscillators

    Published on: May 30, 2014

    14.4K

    Area of Science:

    • Quantum optics
    • Gravitational wave detection
    • Precision measurement

    Background:

    • Modern interferometers like LIGO face sensitivity limits due to quantum noise, specifically radiation pressure and shot noise.
    • Current noise mitigation strategies use static systems, which are not optimized for time-varying signals like gravitational waves.

    Purpose of the Study:

    • To demonstrate a proof-of-principle for dynamically tracking a target signal in an interferometer.
    • To improve the signal-to-noise ratio (SNR) for transient signals by overcoming static noise limitations.

    Main Methods:

    • Developed and tested a dynamic tracking system utilizing an optical spring.
    • Injected white noise to simulate excess shot noise conditions.
    • Compared the performance of the dynamic tracking system against a conventional static configuration.

    Main Results:

    • The dynamic tracking system significantly increased the signal-to-noise ratio (SNR).
    • An SNR improvement of up to a factor of 40 was observed compared to the static configuration.
    • The experiment validated the effectiveness of dynamic tracking for enhancing sensitivity to specific signal frequencies.

    Conclusions:

    • Dynamical tracking using an optical spring is a viable method for enhancing interferometer sensitivity.
    • This technique is particularly beneficial for detecting transient signals with changing frequencies, such as gravitational waves.
    • The results suggest a new approach to noise reduction in precision measurement instruments.