Application of a 3D-Printed Part with Conformal Cooling in High-Pressure Die Casting Mould and Evaluation of Stress...

The article addresses stress formation in the structural 3D-printed elements of a high-pressure die casting die mould used for production of aluminum castings. The 3D-printed elements with conformal cooling are manufactured of 18Ni300 powder. Initial numerical calculations were performed on a test die mould made of standard steel X40CrMoV5 to determine temperature distribution and stress state, providing a baseline for comparing 3D-printed 18Ni300 parts. A database for 18Ni300 material was developed, including optimal heat treatment parameters: aged at 560 °C for 8 h. The resulting tensile strength of approximately ~1600 MPa, yield strength 1550 MPa, and elongation 6-7%, with properties temperature-dependent from 20 °C to 600 °C. Results show that conformal cooling increases stress gradients, highlighting the demands on fatigue strength at elevated temperatures. The study revealed that the heat treatment significantly influences the final properties, with tensile strengths of 1400-2000 MPa and elongation from 1 to 8%. While the heat treatment has a greater impact on the mechanical properties than the printing parameters, optimizing the printing settings remains crucial for ensuring density and quality in the die moulds under cyclic loads.