Related Experiment Video
Updated: Jun 4, 2025

Characterization of Electrode Materials for Lithium Ion and Sodium Ion Batteries Using Synchrotron Radiation Techniques
Published on: November 11, 2013
Electrochemical Cell for Operando Grazing-Incidence X-ray Absorption Spectroscopic Studies of Low-Loaded Electrodes
Maximilian Winzely1, Adam H Clark2, Justus S Diercks1
1Paul Scherrer Institut, Center for Energy and Environmental Science, CH-5232 Villigen, Switzerland.
Abstract:
X-ray absorption spectroscopy (XAS) is a powerful technique that provides information about the electronic and local geometric structural properties of newly developed electrocatalysts, especially when it is performed under operating conditions (i.e., operando). However, the large amounts of catalyst typically needed to achieve sufficiently high spectral quality and temporal resolution can result in working electrodes of several micrometers in thickness. This can in turn lead to an inhomogeneous potential distribution across the electrode, delamination, and/or incomplete utilization of the catalyst layer (CL), as well as to the (partial) shielding of the CL with electrochemically evolved bubbles trapped within its pores. These limitations can be tackled by performing such spectrochemical measurements with low-loaded (and thus thin) electrodes, which call for the acquisition of XAS spectra in fluorescence mode and using an X-ray beam incidence angle of ≤0.1° with regards to the working electrode's substrate plane in a grazing-incidence (GI) configuration. Thus, in this work, we introduce a new spectroelectrochemical flow cell that allows one to perform such measurements in this GI mode and verify its functionality by tracking the potential-induced formation of palladium hydride (PdH) in a Pd nanoparticle-based electrocatalyst. A time resolution of 10 s per spectrum was achieved with a very low Pd-loading of only 30 μgPd/cm2. Moreover, the implementation of an ion-conductive membrane to separate the working- and counter-electrode compartments enables the quantification of reaction products, which, in the case of gaseous species, can be detected in a time-resolved manner by means of mass spectrometry. Chiefly, this allows us to determine the electrocatalytic activity and selectivity of a given material in the same cell configuration used for the spectroscopic measurements and assures a reliable comparison among the results derived from both techniques.
More Related Videos
09:36In Situ Lithiated Reference Electrode: Four Electrode Design for In-operando Impedance Spectroscopy
Published on: September 12, 2018
07:55Elemental-sensitive Detection of the Chemistry in Batteries through Soft X-ray Absorption Spectroscopy and Resonant Inelastic X-ray Scattering
Published on: April 17, 2018
Related Concept Videos
Electrogravimetric Analysis: Overview
To test the completeness of the...
Interfacial Electrochemical Methods: Overview
Electrodes: Overview
There are two main types of electrodes in electrochemical cells. The first type, known as the working or indicator electrode, has a potential that is sensitive to the analyte's concentration and reacts to changes in...
Inductively Coupled Plasma Atomic Emission Spectroscopy: Instrumentation
There are three main types of inductively coupled plasma atomic emission spectroscopy (ICP-AES) instruments: sequential, simultaneous multichannel, and Fourier transform instruments, with the latter being less commonly used....
Voltammetry: Overview
A voltammetric cell uses three electrodes: a working electrode, a reference electrode, and an auxiliary electrode. The redox reactions occur in the working...
Controlled-Current Coulometry: Overview