Quantification of vehicular versus uncorrelated Li+-solvent transport in highly concentrated electrolytes via

Hendrik Kilian1, Tabita Pothmann1, Martin Lorenz2

  • 1Department of Chemistry and Center for Materials Science (WZMW), University of Marburg, Hans-Meerwein-Straße 4, 35032 Marburg, Germany. roling@staff.uni-marburg.de.

Related Concept Videos

Ionic Strength: Overview01:12

Ionic Strength: Overview

The ionic strength of a solution is a quantitative way of expressing the total electrolyte concentration of a solution. This concept was first introduced in 1921 by two American physical chemists, Gilbert N. Lewis and Merle Randall, while describing the activity coefficient of strong electrolytes. During the calculation of ionic strength (I or μ), all the cations and anions are considered. However, the concentration (c) of an ion with a greater charge number (z) has a greater contribution...
1.3K
Electrolytes: van't Hoff Factor03:08

Electrolytes: van't Hoff Factor

Colligative Properties of Electrolytes
The colligative properties of a solution depend only on the number, not on the identity, of solute species dissolved. The concentration terms in the equations for various colligative properties (freezing point depression, boiling point elevation, osmotic pressure) pertain to all solute species present in the solution. Nonelectrolytes dissolve physically without dissociation or any other accompanying process. Each molecule that dissolves yields one...
32.9K
Electrolyte and Nonelectrolyte Solutions02:21

Electrolyte and Nonelectrolyte Solutions

Substances that undergo either a physical or a chemical change in solution to yield ions that can conduct electricity are called electrolytes. If a substance yields ions in solution, that is, if the compound undergoes 100% dissociation, then the substance is a strong electrolyte. Complete dissociation is indicated by a single forward arrow. For example, water-soluble ionic compounds like sodium chloride dissociate into sodium cations and chloride anions in aqueous solution.
62.2K
Titration in Nonaqueous Solvents01:16

Titration in Nonaqueous Solvents

Most acid-base titrations are performed in an aqueous medium. In aqueous titrations, water competes with weaker acids or bases for proton donation or acceptance, leading to ambiguous endpoints in the titration curve. Water also affects the partial ionization of weak acids or bases. For example, water accepts a proton from acetic acid to form hydronium and acetate ions. The hydronium ion formed is a stronger acid than acetic acid, and the acetate ion is a stronger base than water. As a result,...
728
Factors Affecting Activity Coefficient01:17

Factors Affecting Activity Coefficient

The extended Debye-Hückel equation indicates that the activity coefficient of an ion in an aqueous solution at 25°C depends on three partially interdependent properties: the ionic strength of the solution, the charge of the ion, and the ion size. 
The activity coefficient value for an ion is close to one when the solution has almost zero ionic strength, i.e., when the solution shows close to ideal behavior. As the ionic strength of the solution increases from 0 to 0.1 mol/L, a...
736
Electrolysis03:00

Electrolysis

In a galvanic cell, the electrical work is done by a redox system on its surroundings as electrons produced by the spontaneous redox reactions are transferred through an external circuit. Alternatively, an external circuit does work on a redox system by imposing a voltage sufficient to drive an otherwise nonspontaneous reaction in a process known as electrolysis. For instance, recharging a battery involves the use of an external power source to drive the spontaneous (discharge) cell reaction in...
26.0K