Quantifying form resistance is essential for estimating summer low and bankfull flow from stream survey channel...

Reliable estimates of low flow and flood discharge at ungaged locations are required for evaluating stream flow alteration, designing culverts and stream crossings, and interpreting regional surveys of habitat and biotic condition. Very few stream gaging stations are located on small, remote streams, which typically have complex channel morphology. Adequate gaging is also lacking on larger streams that are remote, smaller than those typically gaged, or have channel morphology not conducive to installation of gages. Complex channels typically contain large scale hydraulic roughness elements that dominate flow patterns (i.e., form roughness), making it difficult to measure channel cross-section area and water velocity, or to measure channel volume even where discharge is known. In channels with large channel form roughness, it is equally difficult to estimate discharge using commonly applied equations based on slope and channel dimensions or basin area. We employed a novel approach that explicitly accounts for hydraulic resistance from large wood and riffle-pool morphology (form roughness) in calculating low flow and bankfull discharge from stream and river physical habitat data collected from 4,229 stream and river sites in the conterminous US (CONUS) sampled in 2008-9 and 2013-14 as part of the US Environmental Protection Agency's National Rivers and Streams Assessment (NRSA). Hydraulic resistance derived from form roughness clearly dominated resistance derived from bed particles (particle resistance) during summer low flows in wadeable streams across the spectrum of channel slopes and substrate sizes smaller than boulders. Under bankfull conditions, the influence of form resistance relative to particle resistance was diminished, but form resistance still dominated except in large low gradient rivers lacking complex channels, and in streams or rivers with boulder-size bed particles. We validated our hydraulic resistance estimates by comparing measured discharges with calculated discharges that used those hydraulic resistance estimates along with measured NRSA channel morphology data. Morphology-based summer discharge (low flow) estimates and direct field measurements of discharge in 2,333 wadeable CONUS streams showed reasonable agreement (median difference <2.5x) for discharges ranging from 3.6x10^-5 to 123 m³/s and drainage areas of 0.12 to 171,000 km². In a subset of 759 of NRSA's larger wadeable stream and non-wadeable river sites where nearby U.S. Geological Survey (USGS) gage data were available and adequate, our morphology-based summer discharge estimates agreed fairly well (median difference <2.0x) with USGS 20-y average August mean flows ranging from 0.003 to 16,000 m³/s. Similarly, morphology-based estimates of bankfull flow ranging from 0.3 to 100,000 m³/s agreed reasonably well with the 1.5-yr recurrence interval flood in these gaged sites (median deviation <2.2x). These findings demonstrate the importance of quantifying flow resistance from large-scale form roughness features in natural channels and provide a novel approach for estimating discharge from widely available survey data. This will allow examination of discharge and its ecological influence across the full range of stream and river sizes sampled by NRSA or other synoptic surveys where comprehensive measures of biota, physical habitat, and chemistry are also made. Although these morphology-based estimates exhibit some variability, they are adequate for examining regional patterns in discharge and flow alteration and their association with instream biota and anthropogenic disturbances, providing summer low and bankfull flow information where reliable estimates are lacking.