Evaluation of Almond Shell Activated Carbon for Dye (Methylene Blue and Malachite Green) Removal by Experimental and...

The present work analyzes the behavior of an activated carbon fabricated from almond shells for the removal of cationic dyes (methylene blue, MB, and malachite green, MG) by adsorption from aqueous solutions. The carbonized precursor was activated with KOH at a 1:2 (w/w) ratio with the objective of increasing both the surface area and the pore volume. Both non-activated and activated carbon were characterized in different aspects of interest in dye adsorption studies (surface structure, point of zero charge, specific surface area, and pore size distribution). The effect of the dye's initial concentration and adsorbent dosage on dye removal efficiency and carbon adsorption capacity was studied. Adsorption kinetics were analyzed under different experimental conditions, and different models were assayed to determine the adsorption mechanism. Dye adsorption in the adsorbent surface could be considered the rate-limiting step. Different adsorption equilibrium models were evaluated to fit the experimental data. This adsorbent allowed us to reach high Langmuir adsorption capacity for both dyes (MB: 341 mg·g^-1, MG: 364 mg·g^-1 at 25 °C and 0.5 g·L^-1). Moreover, kinetic and equilibrium adsorption data have been used to simulate breakthrough curves in a packed-bed column using different conditions (bed length, liquid flowrate, and dye initial concentration). The simulation results showed that almond shell activated carbon is a suitable adsorbent for methylene blue and malachite green removal from wastewater.