Distinct patterns of volcano deformation for hot and cold magmatic systems

Gregor Weber1, Juliet Biggs2, Catherine Annen3

  • 1COMET, School of Earth Sciences, University of Bristol, Bristol, UK. gregor.weber@bristol.ac.uk.

Nature Communications
|January 9, 2025
PubMed

Related Concept Videos

Temperature Dependent Deformation01:12

Temperature Dependent Deformation

In a nonhomogeneous rod made up of steel and brass, restrained at both ends and subjected to a temperature change, several steps are involved in calculating the stress and compressive load. Due to the problem's static indeterminacy, one end support is disconnected, allowing the rod to experience the temperature change freely. Next, an unknown force is applied at the free end, triggering deformations in the rod's steel and brass portions. These deformations are then calculated and added...
138
Isothermal Processes01:21

Isothermal Processes

A thermodynamic process that occurs at constant temperature is called an isothermal process. Heat slowly flows into the system or out of the system to maintain thermal equilibrium. Processes involving phase changes like water evaporation into steam or freezing water into ice at a constant temperature are examples of Isothermal Processes.
An ideal gas can also undergo isothermal expansion or compression.
For example, consider 1 mole of an ideal gas inside an isolated cylinder at initial volume V...
3.5K
Divergence and Curl of Magnetic Field01:26

Divergence and Curl of Magnetic Field

The magnetic field due to a volume current distribution given by the Biot–Savart Law can be expressed as follows:
2.8K
Thermal Strain01:19

Thermal Strain

Thermal strain is a concept that arises when we consider how temperature changes affect structures. Unlike the conventional assumption that structures remain constant under load, real-world scenarios often involve temperature fluctuations that can significantly impact these structures. Consider a homogeneous rod with a uniform cross-section resting freely on a flat horizontal surface. If the rod's temperature increases, the rod elongates. This elongation is proportional to the temperature...
616
Deformation of Member under Multiple Loadings01:11

Deformation of Member under Multiple Loadings

When a rod is made of different materials or has various cross-sections, it must be divided into parts that meet the necessary conditions for determining the deformation. These parts are each characterized by their internal force, cross-sectional area, length, and modulus of elasticity. These parameters are then used to compute the deformation of the entire rod.
In the case of a member with a variable cross-section, the strain is not constant but depends on the position. The deformation of an...
155
Isochoric and Isobaric Processes01:21

Isochoric and Isobaric Processes

A thermodynamic process that occurs at constant volume is called an isochoric process. According to the first law of thermodynamics, heat supplied or removed from the system is partially utilized to perform work and change the internal energy of the system. However, in an isochoric process, the volume remains constant. Hence, the work done by the system is zero. Therefore, the exchange of heat changes the internal energy of the system only. 
Suppose 1000 g of water is heated from 40...
3.3K