Study on Fire Temperature Field in Small-Section Steel-Shell Concrete Immersed Tube Tunnel Structure Based on CFD-FEM...

Small-section steel-shell concrete immersed tube tunnels are intended for minibuses and have a low fire heat release rate. Standard fire rise curves do not apply to such tunnels. In this study, a coupled method of computational fluid dynamics (CFD) and the finite element method (FEM) was used to simulate the structural temperature distribution in tunnels. Firstly, a tunnel fire dynamics model was established to obtain the inhomogeneous temperature field during tunnel fires. Subsequently, a three-dimensional heat transfer analysis model for the tunnel tube section was established to simulate the temperature transfer characteristics of the tunnel structure with and without fire protection measures under different types of vehicle fires. This study showed that because steel has a higher thermal conductivity, at the same depth, the temperatures were the highest in T-ribs, followed by partitions, and the lowest in concrete; however, the steel components inside the tunnel minimally affected the tunnel temperature. Without fire protection, the steel shell's surface temperature exceeded 300 °C in as little as 500 s. Temperature's primary impact on the tunnel's steel structure was within 30 cm of the steel shell's surface, and on concrete, it was within 20 cm. The greatest temperature difference between the partition and concrete occurred 10 cm from the steel shell's surface. These results fill the knowledge gap on heat transfer in these tunnels and have positive practical significance for the fire resistance design of tunnels.