Thermal Conductivity of Liquid trans-1,2-Dichloroethene (R-1130(E)): Measurement and Modeling

The thermal conductivity of liquid trans-1,2-dichloroethene (R-1130(E)) was measured at temperatures ranging from 240 K to 340 K and pressures up to 25 MPa using a transient hot-wire instrument. A total of 447 thermal conductivity data points were measured along six isotherms. Each isotherm includes data at nine pressures, which were chosen to be at equal density increments starting at a pressure of 0.1 MPa (or slightly above the saturation pressure of R-1130(E) at temperatures above its normal boiling point) to a maximum pressure of 25 MPa. The combined expanded uncertainty of the presented experimental data is 1.4% at a 95% confidence level. The experimental data were used to evaluate the performance of an extended corresponding states (ECS) model and a residual entropy scaling (RES) model. Both models were applied in a totally predictive mode, and in a mode where the experimental data were used to tune the model parameters. A volume-translated Peng-Robinson equation of state was used to provide thermodynamic properties needed to apply both models. In a totally predictive mode, the ECS model had an average absolute relative deviation (Δ_AARD) of 6.89% relative to the experimental data with the largest deviation being - 8.33%. The RES model in a totally predictive mode showed an Δ_AARD of 2.55% with the largest deviation being - 5.81%. When model parameters were fitted to the experimental data, both the ECS and the RES model represented the experimental data to within its uncertainty of 1.4%.