Related Experiment Video
Updated: Jun 1, 2025

The MODS method for diagnosis of tuberculosis and multidrug resistant tuberculosis
Published on: August 11, 2008
Update of diagnostic methods in tuberculosis (TB)
Mario José Matteo1, María Cecilia Latini2, Davor Nicolás Martinovic3
1Laboratorio de TB Dr Abel Cetrangolo, Hospital F. J. Muñiz, Ciudad Autónoma de Buenos Aires (CABA), Argentina.
Abstract:
The WHO aims to reduce the number of deaths from TB by 95% and decrease its incidence rate by 90% between 2015 and 2035. The recommended rapid diagnostic tests are accurate and cost-effective, allow for a prompt start to treatment, and influence other outcomes that are important to the patient. To detect latent infection, the tuberculin skin test and interferon γ release (IGRA) tests are used. Although IGRA is an expensive test, it has greater specificity and is not affected by previous exposure to the BCG vaccine, among other advantages. For the diagnosis of active TB, smear microscopy is commonly employed. Culture is a more sensitive, but also more complex method. It constitutes the definitive diagnosis and allows phenotypic sensitivity tests to be performed. TB-LAM has limited sensitivity; however, unlike other methodologies, it has shown promising results in individuals living with HIV and CD4 T-cell counts below 200/mm3. Finally, among the molecular biology-based tests, commercial methods using real-time PCR allow mass diagnosis and sensitivity testing to first- and second-line drugs to be conducted within a few hours of receiving the sample. These are highly sensitive and specific tests, and their use is recommended as the initial diagnostic test in both pulmonary and extrapulmonary TB cases.
Related Concept Videos
Pulmonary Tuberculosis IV
Several diagnostic approaches are used to detect TB. The conventional method is the Tuberculin Skin Test (TST), also known as the Mantoux test. However, this method has...
Pulmonary Tuberculosis V
Latent tuberculosis infection occurs when TB bacteria are present in a person's body, but are not causing illness or symptoms. It is not contagious, and preventive treatment is crucial to avoid the...
Pulmonary Tuberculosis III
The first classification is based on the development of the disease, and it includes the following categories:
Pulmonary Tuberculosis II
Here is a detailed explanation of its pathophysiology:
Transmission: The process begins when a person inhales droplet nuclei containing M. tuberculosis. These are typically released into the air when an individual with pulmonary or...
Pulmonary Tuberculosis I
Causative Organism
The primary infectious agent causing tuberculosis is Mycobacterium tuberculosis, a slow-growing, acid-fast, aerobic rod that exhibits sensitivity to heat and ultraviolet light. Instances of Mycobacterium bovis and Mycobacterium avium contributing to the development of TB infection are rare.
Mode of...
Pneumonia III: Complications and Assessment

