Related Experiment Video

Updated: Jun 1, 2025

Biomass Conversion to Produce Hydrocarbon Liquid Fuel Via Hot-vapor Filtered Fast Pyrolysis and Catalytic Hydrotreating
11:28

Biomass Conversion to Produce Hydrocarbon Liquid Fuel Via Hot-vapor Filtered Fast Pyrolysis and Catalytic Hydrotreating

Published on: December 25, 2016

26.4K

Performance and emissions of diesel engine combustion lubricated with Jatropha bio-lubricant and MWCNT additive

Rajendra Uppar1, P Dinesha1, Shiva Kumar2

  • 1Department of Mechanical and Manufacturing Engineering, Manipal Institute of Technology, Manipal Academy of Higher Education, Manipal, 576104, India.

Scientific Reports
|January 20, 2025
PubMed

Keywords:
BiolubricantEmissionEpoxidationFriction powerJatrophaTransesterification

More Related Videos

Author Spotlight: Employing Green-Chemistry Principles for Safe and Sustainable Synthesis of Biodiesels04:40

Author Spotlight: Employing Green-Chemistry Principles for Safe and Sustainable Synthesis of Biodiesels

Published on: April 19, 2024

1.0K
Original Experimental Approach for Assessing Transport Fuel Stability09:48

Original Experimental Approach for Assessing Transport Fuel Stability

Published on: October 21, 2016

9.3K

Related Concept Videos

Otto and Diesel Cycle01:27

Otto and Diesel Cycle

An Otto engine is a four-stroke engine that uses a mixture of gasoline and air as the working fuel. The fuel is injected into the cylinder, and the piston is moved completely down so that the cylinder is at maximum volume. By moving the piston up, adiabatic compression takes place. The spark plug ignites the gasoline-air mixture, and the burning fuel adds heat to the system at a constant volume. The heated mixture expands adiabatically and gets further cooled by exhausting heat, and this cyclic...
1.4K
Internal Combustion Engine01:20

Internal Combustion Engine

The internal combustion engine is a heat engine that uses the byproducts of combustion as the working fluid instead of using a heat transfer medium to transfer heat. The combustion is done in a way that produces high-pressure combustion products that can be expanded through a turbine or piston to create work. Internal combustion engines can again be categorized into three kinds: (1) spark ignition gasoline engines, most commonly used in automobiles, (2) compression ignition diesel engines that...
987
Work Done in an Adiabatic Process01:20

Work Done in an Adiabatic Process

Consider the adiabatic compression of an ideal gas in the cylinder of an automobile diesel engine. The gasoline vapor is injected into the cylinder of an automobile engine when the piston is in its expanded position. The temperature, pressure, and volume of the resulting gas-air mixture are 20 °C, 1.00 x 105 N/m2, and 240 cm3 , respectively. The mixture is then compressed adiabatically to a volume of 40 cm3. Note that, in the actual operation of an automobile engine, the compression is not...
3.1K
Benzene to 1,4-Cyclohexadiene: Birch Reduction Mechanism01:18

Benzene to 1,4-Cyclohexadiene: Birch Reduction Mechanism

Birch reduction uses solvated electrons as reducing agents. The reaction converts benzene to 1,4-cyclohexadiene. The reaction proceeds by the transfer of a single electron to the ring to form a benzene radical anion. This anion is highly basic—it abstracts a proton from the alcohol to form a cyclohexadienyl radical. Another single electron transfer gives the cyclohexadienyl anion. A proton transfer from the alcohol forms 1,4-cyclohexadiene. Since this reduction occurs via radical anion...
2.2K
Bioremediation00:46

Bioremediation

Bioremediation is the use of prokaryotes, fungi, or plants to remove pollutants from the environment. This process has been used to remove harmful toxins in groundwater as a byproduct of agricultural run-off and also to clean up oil spills.
18.2K