IPEM code of practice for proton therapy dosimetry based on the NPL primary standard proton calorimeter calibration...

Internationally, reference dosimetry for clinical proton beams largely follows the guidelines published by the International Atomic Energy Agency (IAEA TRS-398 Rev. 1 (2024). This approach yields a relative standard uncertainty of 1.7% (k= 1) on the absorbed dose to water determined under reference conditions. The new IPEM code of practice presented here, enables the relative standard uncertainty on the absorbed dose to water measured under reference conditions to be reduced to 1.0% (k= 1). This improvement is based on the absorbed dose to water calibration service for proton beams provided by the National Physical Laboratory (NPL), the UK's primary standards laboratory. This significantly reduced uncertainty is achieved through the use of a primary standard level graphite calorimeter to derive absorbed dose to water directly in the clinical department's beam. This eliminates the need for beam quality correction factors (kQ,Q0) as required by the IAEA TRS-398 approach. The portable primary standard level graphite calorimeter, developed over a number of years at the NPL, is sufficiently robust to be useable in the proton beams of clinical facilities both in the UK and overseas. The new code of practice involves performing reference dosimetry measurements directly traceable to the primary standard level graphite calorimeter in a clinical proton beam. Calibration of an ionisation chamber is performed in the centre of a standard test volume (STV) of dose, defined here to be a 10 × 10 × 10 cm volume in water, centred at a depth of 15 cm. Further STVs at reduced and increased depths are also utilised. The designated ionisation chambers are Roos-type plane-parallel chambers. This article provides all the necessary background material, formalism, and specifications of reference conditions required to implement reference dosimetry according to this new code of practice. The Annexes provide a detailed review of ion recombination and how this should be assessed (Annex A1) and detailed work instructions for creating and delivering the STVs (Annex A2).