Related Experiment Video
Updated: May 31, 2025
Preparation of Expanded Chitin Foams and their Use in the Removal of Aqueous Copper
Published on: February 27, 2021
Lightweight 3D-printed chitosan/MXene aerogels for advanced electromagnetic shielding, energy harvesting, and thermal
Amirjalal Jalali1, Tanmay Gupta2, Viktoriya Pakharenko2
1Microcellular Plastics Manufacturing Laboratory, Department of Mechanical and Industrial Engineering, University of Toronto, 5 King's College Road, Toronto, Ontario M5S 3G8, Canada; Center for Biocomposites & Biomaterials Processing, University of Toronto, Toronto, Ontario M5S 3B3, Canada.
Abstract:
This study focuses on the fabrication of 3D-printed chitosan/Ti3C2Tx-MXene aerogels with varying MXene concentrations (1, 2, 5, and 10 wt%) using the direct ink writing (DIW) method. The inks were freeze-dried to form aerogels, and FTIR and XRD analyses confirmed interactions between chitosan and MXene molecules, leading to increased spacing between MXene nanosheets. Rheological testing showed improved shear-thinning behavior, enhancing printability. A higher MXene content boosted the electrical conductivity, dielectric properties, and electromagnetic interference (EMI) shielding effectiveness, with the 10 wt% MXene aerogel achieving an EMI shielding effectiveness of 27 dB. The thermal conductivity initially decreased but later increased with higher MXene concentrations. Mechanical tests indicated enhanced Young's modulus and tensile strength with more MXene, but the elongation at break decreased. The printed aerogels were used in a Triboelectric Nanogenerator (TENG), showing an increase in output voltage from 22 V for pure chitosan aerogels to 110 V for 2 wt% MXene, with a slightly lower increase in current. However, exceeding 2 wt% MXene led to reduced performance. This study highlights the potential of printed aerogels for energy harvesting, EMI shielding, and thermal insulation applications.
