Improving Tracking of Selective Attention in Hearing Aid Users: The Role of Noise Reduction and Nonlinearity

Johanna Wilroth1, Emina Alickovic2,3, Martin A Skoglund2,3

  • 1Automatic Control, Department of Electrical Engineering, Linköping University, Linköping 581 83, Sweden Johanna.wilroth@liu.se.

Eneuro
|January 29, 2025
PubMed

Related Concept Videos

Hearing01:31

Hearing

When we hear a sound, our nervous system is detecting sound waves—pressure waves of mechanical energy traveling through a medium. The frequency of the wave is perceived as pitch, while the amplitude is perceived as loudness.
Characteristics of Practical Op Amps01:16

Characteristics of Practical Op Amps

A difference amplifier, a crucial component in numerous electronic devices, ideally amplifies only the difference-mode signal, which is the difference between two input signals. However, in practical circuits, the output voltage depends on both the differential gain and the common-mode gain.
The ratio of differential gain to the common-mode gain is defined as the common-mode rejection ratio (CMRR). This ratio quantifies the ability of operational amplifiers (op-amps) to reject common-mode...
Parallel Resonance01:23

Parallel Resonance

The parallel RLC circuit is an arrangement where the resistor (R), inductor (L), and capacitor (C) are all connected to the same nodes and, as a result, share the same voltage across them. The parallel RLC circuit is analyzed in terms of admittance (Y), which reflects the ease with which current can flow. The admittance is given by:
Active Filters01:25

Active Filters

Active filters are electronic circuits that use operational amplifiers (op-amps), resistors, and capacitors to filter out unwanted frequency components from a signal. A first-order low-pass active filter is designed to pass signals with a frequency lower than a certain cutoff frequency and attenuate frequencies higher than that cutoff frequency. The transfer function for a first-order low-pass active filter is:
Design Example: Vintage Mixing Console01:17

Design Example: Vintage Mixing Console

A sound engineer at a music company recently encountered a problem. The output from their newly acquired studio's vintage mixing console was too low for the requirements of modern recording equipment. To rectify this situation, the engineer decided to design an audio pre-amplifier using an operational amplifier (op-amp) to boost the signal level.
The specifications for the pre-amplifier were clear. It needed to amplify the audio signal by a factor of 10, have an input impedance above 10...
Auditory Perception01:17

Auditory Perception

The auditory system is essential for sound perception, utilizing various critical structures. When sound waves enter the outer ear, they travel through the ear canal and cause the eardrum to vibrate. These vibrations are then transmitted to the middle ear, where three tiny bones – the malleus, incus, and stapes – amplify the sound. This amplification is crucial, as it ensures that the sound vibrations are strong enough to be conveyed to the inner ear. These vibrations then reach the cochlea, a...