Related Experiment Video
Updated: Jul 13, 2026

12:26
Integrating Remote Sensing with Species Distribution Models; Mapping Tamarisk Invasions Using the Software for Assisted Habitat Modeling (SAHM)
Published on: October 11, 2016
Lynn T. Landmesser (1943-2024)
Nicholas C Spitzer1, Ben W Strowbridge2
1University of California San Diego, La Jolla, CA, USA. nspitzer@ucsd.edu.
Nature Neuroscience
|January 30, 2025
Summary
No abstract available in PubMed .
Related Concept Videos
The Colonization of Land
Changes in the environment of the early Earth drove the evolution of organisms. As prokaryotic organisms in the oceans began to photosynthesize, they produced oxygen. Eventually, oxygen saturated the oceans and entered the air, resulting in an increase in atmospheric oxygen concentration, known as the oxygen revolution approximately 2.3 billion years ago. Therefore, organisms that could use oxygen for cellular respiration had an advantage. More than 1.5 years ago, eukaryotic cells and...
Lenz's Law
The direction in which the induced emf drives the current around a wire loop can be found through the negative sign. However, it is usually easier to determine this direction with Lenz's law, named in honor of its discoverer, Heinrich Lenz (1804–1865). Lenz's law states that the direction of the induced emf drives the current around a wire loop always to oppose the change in magnetic flux that causes the emf.
If a bar magnet is moved toward a coil such that the magnetic flux through the coil...
If a bar magnet is moved toward a coil such that the magnetic flux through the coil...
Region of Convergence of Laplace Tarnsform
The Region of Convergence (ROC) is a fundamental concept in signal processing and system analysis, particularly associated with the Laplace transform. The ROC represents an area in the complex plane where the Laplace transform of a given signal converges, determining the transform's applicability and utility.
Consider a decaying exponential signal that begins at a specific time. When deriving its Laplace transform, the time-domain variable is replaced with a complex variable. This substitution...
Consider a decaying exponential signal that begins at a specific time. When deriving its Laplace transform, the time-domain variable is replaced with a complex variable. This substitution...
Boundary Conditions: Lossless Lines
Consider a single-phase, two-wire, lossless transmission line terminated by an impedance at the receiving end and a source with Thevenin voltage and impedance at the sending end. The line, with length, has a surge impedance and wave velocity determined by the line's inductance and capacitance.
At the receiving end, the boundary condition states that the voltage equals the product of the receiving-end impedance and current. This relationship is expressed as a function of the incident and...
At the receiving end, the boundary condition states that the voltage equals the product of the receiving-end impedance and current. This relationship is expressed as a function of the incident and...
Latitudes and Departures
Latitudes and departures are essential concepts in surveying, providing a systematic way to analyze the projections of traverse lines. These projections allow surveyors to interpret a line's north-south and east-west components, which are crucial for precisely calculating areas, bearings, and lengths. Latitude is the north-south projection of a line, calculated as the product of the line's length and the cosine of its bearing. Departure, conversely, is the east-west projection obtained by...
Geoid and Ellipsoid
The Earth's shape is best described as an ellipsoid, a slightly flattened sphere created by rotating an ellipse around its minor axis. This flattening results in the polar axis being about 21 kilometers shorter than the equatorial axis. In contrast, the geoid represents the Earth's gravitational shape and aligns with the mean sea level (MSL). The geoid is an irregular equipotential surface where gravity is perpendicular at every point. Variations in Earth's mass distribution cause geoid...

