Protoplast dehydration correlated with heat resistance of bacterial spores

Water content of the protoplast in situ within the fully hydrated dormant bacterial spore was quantified by use of a spore in which the complex of coat and outer (pericortex) membrane was genetically defective or chemically removed, as evidenced by susceptibility of the cortex to lysozyme and by permeability of the periprotoplast integument to glucose. Water content was determined by equilibrium permeability measurement with 3H-labeled water (confirmed by gravimetric measurement) for the entire spore, with 14C-labeled glucose for the integument outside the inner (pericytoplasm) membrane, and by the difference for the protoplast. The method was applied to lysozyme-sensitive spores of Bacillus stearothermophilus, B. subtilis, B. cereus, B. thuringiensis, and B. megaterium (four types). Comparable lysozyme-resistant spores, in which the outer membrane functioned as the primary permeability barrier to glucose, were employed as controls. Heat resistances were expressed as D100 values. Protoplast water content of the lysozyme-sensitive spore types correlated with heat resistance exponentially in two distinct clusters, with the four B. megaterium types in one alignment, and with the four other species types in another. Protoplast water contents of the B. megaterium spore types were sufficiently low (26 to 29%, based on wet protoplast weight) to account almost entirely for their lesser heat resistance. Corresponding values of the other species types were similar or higher (30 to 55%), indicating that these spores depended on factors additional to protoplast dehydration for their much greater heat resistance.