Microstructure and Corrosion Behaviors of Gas Tungsten Arc Welds for Borated Stainless Steel Using Various Filler...

In this study, the microstructure and corrosion behavior of gas tungsten arc (GTA) welds of borated stainless steel (BSS) with a boron content of 1.62 wt.% were investigated using various filler metals. The filler metals used in this study were 308L, 309L, and 310 without the B component. A small amount of the B component was observed in the weld metal (WM) of all specimens, even though none of the filler wires contained boron. This result was caused by the dilution of the B component from the BM into the WM by the welding heat. The segregation of boron in the WM resulted in Cr-depleted areas, which negatively affected the corrosion resistance of the welded specimens. The corrosion resistance of 308L WM with the highest fraction of B components was the most deteriorated, whereas 309L WM with the lowest boron content exhibited the best corrosion resistance. Using a filler metal without the B component is expected to effectively improve the weldability and corrosion resistance of BSS; however, it can also reduce the neutron absorption capacity. Therefore, for BSS to be used as a spent nuclear fuel storage container material, the boron content of the filler metal must be carefully considered. This study provides a foundation for research aimed at improving the development and applicability of filler metals in borated stainless steel and makes it competitive for application in fourth-generation nuclear power systems.