Solubility and Diffusion of Main Biogas Components in a Glassy Polysulfone-Based Membrane

Biogas, one of the important controllable renewable energy sources, may be split into two streams: bio-CH₄ and bio-CO₂ using, among others, membrane processes. The proper optimization of such processes requires the knowledge of phenomena accompanying each specific CH₄-CO₂-membrane system (e.g., competitive sorption or swelling). The phenomena were analyzed for the polysulfone-based membrane used in a developed adsorptive-membrane system for biogas separation. The Dual Mode Sorption and partial immobilization models were used to describe the solubility and diffusion of CO₂, CH₄ and their mixtures in this material. The parameters of the models were determined based on pure-gas sorption isotherms measured gravimetrically and permeances of CO₂/CH₄ mixture components from our previous studies. It was found, among other things, that the membrane swelling caused by CO₂ was observed for pressures higher than 5 bar. The real selectivity (permselectivity) of CO₂ vs. CH₄ is significantly lower than the selectivity of pure gases (ideal selectivity), while the solubility selectivity of CO₂ vs. CH₄ in the mixture is higher than that of pure gases. This is due to the better affinity of CO₂ towards the tested polysulfone membrane, making CO₂ the dominant component in competitive sorption. The reduction in the permselectivity is mainly due to an approximately two-fold decrease in the CO₂ diffusion rate in the presence of CH₄. It was also found that the fraction of solubility in the fractional free volume (FFV) is dominant for both gases, pure and mixed, reaching 65-73% of the total solubility. Moreover, in CO₂/CH₄ mixtures, the mobility of methane in FFV disappears, which additionally confirms the displacement of methane by CO₂ from FFV.