Research and Application of Microwave Microstrip Transmission Line-Based Icing Detection Methods for Wind Turbine...

In areas where there is high humidity and freezing rain, there is a tendency of blade icing on wind turbines. It results in energy dissipation and mechanical abrasion and also creates a safety concern due to the risk of having falling ice. Real-time online detection of icing is crucial in the enhancement of power generation efficiency and in the safety of wind turbines. The current methods of icing detection that use ultrasound, optics, vibration, and electromagnetics are already studied. But these methods have their drawbacks, including small detection ranges, low accuracy, large size, and challenges in distributed installation, making it hard to capture the real-time dynamics of the icing and de-icing processes on the wind turbine blades. To this end, this paper presents a new blade surface icing detection technique using microstrip lines. This approach uses the impact of icing state and thickness on the effective dielectric constant of the microstrip line surface. This paper presents the analysis of time-domain features of microwave signals, which facilitates the identification of both the icing state and the corresponding thickness. Simulation and experimental measurement of linear and S-shaped microstrip sensors are used in this research in order to compare the response of the sensors to the variation in the thickness of the icing layer. It is seen that for icing thickness ranging from 0 mm to 6 mm, the imaginary part of the S21 parameter of the S-shaped microstrip line has a more significant change than that of the linear microstrip line. The above experiments also confirm that the phase shift value of the S-shaped microstrip line is always higher than that of the linear microstrip line for the same variation of icing thickness, which proves that the S-shaped microstrip line is more sensitive than the linear one. Also, it was possible to establish the relationship between the phase shift values and icing thickness, which makes it possible to predict the icing thickness. The developed microwave microstrip detection technology is intended for usage in the wind turbine blade icing and similar surface detection areas. This method saves the size and thickness of icing sensors, which makes it possible to conduct measurements at various points. This is especially beneficial for usage in wind turbine blades and can be further applied in aerospace, automotive, and construction, especially the bridges.