Related Experiment Video

Updated: May 27, 2025

An Optimized Rhizobox Protocol to Visualize Root Growth and Responsiveness to Localized Nutrients
07:45

An Optimized Rhizobox Protocol to Visualize Root Growth and Responsiveness to Localized Nutrients

Published on: October 22, 2018

15.7K

Impact of root distribution patterns on the elastic deformation resistance capacity and pore water development in

Shumin Lyu1,2, Jun Li3,4, Xiaodong Ji1,2

  • 1Department of Civil Engineering, Beijing Forestry University, Beijing, 100083, People's Republic of China.

Scientific Reports
|February 15, 2025
PubMed

Keywords:
Dynamic loadingElastic deformationPore water pressure modelRoot distribution patternsRoot reinforced soil

More Related Videos

A Simple Protocol for Mapping the Plant Root System Architecture Traits11:09

A Simple Protocol for Mapping the Plant Root System Architecture Traits

Published on: February 10, 2023

2.7K
Biomimetic Replication of Root Surface Microstructure using Alteration of Soft Lithography05:53

Biomimetic Replication of Root Surface Microstructure using Alteration of Soft Lithography

Published on: August 5, 2020

5.6K

Related Concept Videos

Relation between Poisson's ratio, Modulus of Elasticity and Modulus of Rigidity01:15

Relation between Poisson's ratio, Modulus of Elasticity and Modulus of Rigidity

Deformation occurs in axial and transverse directions when an axial load is applied to a slender bar. This deformation impacts the cubic element within the bar, transforming it into either a rectangular parallelepiped or a rhombus, contingent on its orientation. This transformation process induces shearing strain. Axial loading elicits both shearing and normal strains. Applying an axial load instigates equal normal and shearing stresses on elements oriented at a 45° angle to the load axis.
241
Residual Stresses in Bending01:18

Residual Stresses in Bending

In the study of elastoplastic members subjected to bending moments, understanding the loading and unloading phases is crucial for assessing material behavior and structural integrity. During the loading phase, as the bending moment increases, the material initially responds elastically, adhering to Hooke's Law, where stress is directly proportional to strain. When the load exceeds the yield strength, plastic deformation occurs, resulting in permanent strain and deformation that remains even...
149
Pore Size Distribution01:23

Pore Size Distribution

In concrete, the pore size distribution significantly influences the material's properties. Capillary pores, markedly larger than gel pores, form a vast network within partially hydrated cement paste, reducing the concrete's strength and increasing its permeability. This heightened permeability leads to a greater risk of damage from environmental factors like freeze-thaw cycles and chemical attacks, with the extent of vulnerability also being tied to the water-to-cement ratio.
Adequate...
82
Plastic Behavior01:21

Plastic Behavior

A material's elastic behavior is characterized by the disappearance of stress once the load is removed, allowing the material to return to its original state. However, when stress surpasses the yield point, yielding commences, marking the onset of plastic deformation or permanent set. This change from elastic to plastic behavior is influenced by the peak stress value and the duration before the load is removed. An intriguing observation occurs when a specimen is loaded, unloaded, and...
185
Members Made of Elastoplastic Material01:19

Members Made of Elastoplastic Material

The behavior of elastoplastic materials under bending stresses, particularly in structural members with rectangular cross-sections, is crucial for predicting material responses and understanding failure modes. Initially, when a bending moment is applied, the stress distribution across the section follows Hooke's Law and is linear and elastic. This distribution means the stress increases from the neutral axis to the maximum at the outer fibers, up to the elastic limit.
As the bending moment...
93
Water and Mineral Acquisition02:34

Water and Mineral Acquisition

Specialized tissues in plant roots have evolved to capture water, minerals, and some ions from the soil. Roots exhibit a variety of branching patterns that facilitate this process. The outermost root cells have specialized structures called root hairs that increase the root surface, thus increasing soil contact. Water can passively cross into roots, as the concentration of water in the soil is higher than that of the root tissue. Minerals, in contrast, are actively transported into root cells.
29.5K