Detection and comparative analysis of VOCs between tomato and pepper based on GC×GC-TOFMS
Sihui Guan1,2, Chenxu Liu1, Meiying Ruan1
1State Key Laboratory for Managing Biotic and Chemical Threats to the Quality and Safety of Agro-Products, Institute of Vegetables, Zhejiang Academy of Agricultural Sciences, Hangzhou, 310021, P.R. China.
Abstract:
This study aimed to identify and compare the flavor substances in mature tomato and pepper fruits using flavoromics based on GC×GC-TOF-MS. A total of 1560 volatile substances were identified, including 627 tomato specific substances and 534 pepper specific substances. Esters were identified as the distinguishing factor in the aroma profiles of the two. ROAV, an effective flavor evaluation criterion, can help identify the main contributors to flavor that can be detected by the taste buds. VOCs with ROAV > 1 are typically regarded as the key flavor contributors. Interestingly, it was found that tomato and pepper shared three common VOCs (2-nonenal, (E)-; 2-octenal, (E)-; and furan, 2-pentyl-.), which exhibited higher ROAV in both. Except for the three common VOCs, heptanal; 2-dodecenal, (E)-; 1-octen-3-one; 2-undecanone in tomato and pyrazine, 2-methoxy-3-(2-methylpropyl)- in pepper were identified to be contributive to their corresponding aromatic flavor (ROVA > 1), respectively. The contents of 138 volatile metabolites differ between tomato and pepper. Among them, acetoin, dodecanal and 1-decanol demonstrated highest fold change (Log2FC > 10). The flavor wheel shows the most obvious flavor characteristic of both tomato and pepper is sweet flavor. In addition, green, fruity, herbal, woody and apple flavors are prominent in pepper, while waxy, citrus and fatty flavors are prominent in tomato.
Related Concept Videos
Gas Chromatography–Mass Spectrometry (GC–MS)
A gas chromatograph consists of a long, narrow capillary column with a polysiloxane coating on the inner wall....
Gas Chromatography: Overview of Detectors
A non-destructive detector allows a sample to be analyzed without altering or consuming it, meaning the sample can be collected after detection for further analysis. Examples include thermal conductivity detectors and...
Gas Chromatography: Types of Detectors-II
Gas Chromatography: Introduction
In GC, a sample is vaporized and mixed with an inert carrier gas (the mobile phase), which transports it through a...
Gas Chromatography: Types of Detectors-I
TCD is the earliest and most widely used detector that operates by measuring the changes in the thermal conductivity of the carrier gas. When a sample compound enters the detector,...
Chromatographic Methods: Classification
Chromatographic techniques are typically named by...


