Numerical Study of Rice Grain Milling Uniformity in the Abrasive Milling Process

The uniform removal of the bran layer significantly enhances the nutritional and economic benefits of rice. However, the influence of parameter conditions on the uniformity of milling in the abrasive milling process remains unclear. This is not conducive to improving the quality of rice milling. In this study, the effects of rotational speed and filling volume on milling uniformity in abrasive milling were investigated by combining experimental methods and simulation. The results showed that the higher the rotational speed, the more uniform the milling. The higher the filling volume, the more non-uniform the milling. The main reason for the variation in milling uniformity is the axial and radial position exchange of the rice particles in the milling chamber. The more frequent the exchange, the higher the milling uniformity. Subsequently, the frequency of position exchange was quantitatively characterised using axial and radial exchange rates, respectively. The rotational speed and filling volume change the position exchange frequency by affecting the rotational kinetic energy of the rice particles and the degree of dense rice population, respectively. These findings are useful in promoting rice loss reduction and nutritional balance.