Effects of Polymeric Crosslinker on Network Structure, Morphology, and Properties of Liquid Isoprene Rubber

In this study, we investigated the influence of an epoxy end-capped polypropylene oxide crosslinker (epoxy-PPO) on the formation of the crosslinked network structure, the stress-strain response, and the electro-mechanical actuation performance of a maleic anhydride functionalized liquid isoprene rubber (LIR). The crosslinker amount varied from 10 (C-LIR-10) to 50 (C-LIR-50) weight parts per hundred parts (phr) of LIR. The swelling test of the cured rubbers revealed that C-LIR-20 formed the densest crosslinked network with the lowest chloroform uptake value within this series. The crosslinked rubber became stiffer in tensile response upon increasing the epoxy-PPO amount from C-LIR-10 to C-LIR-20 and then softened at higher amounts. The SEM measurements were used to relate this composition-induced softening of the rubbers to the phase morphology evolution from nanoscale homogeneity in C-LIR-10 to microscale segregations of excess crosslinkers in C-LIR-50. The use of epoxy-PPO improved the dielectric constant value of LIR; however, the leakage current through the films also increased from 25 µA DC to 320 µA DC for LIR-30 and LIR-50, respectively, during DEA operation. The electro-mechanical actuation tests with circular actuators showed that the C-LIR-10 elastomer film demonstrated a radial strain of 1.7% on activation at an electric field strength of 17.5 V/µm. At higher crosslinker amounts, the close proximity of excess epoxy-PPO molecules caused leakage current across elastomer films thus diminishing the actuation strain of otherwise relatively softer elastomers with higher dielectric constant values.