Human-in-the-Loop Optimization of Hip Exoskeleton Assistance During Stair Climbing

This study applies human-in-the-loop optimization to identify optimal hip exoskeleton assistance patterns for stair climbing.

Ten participants underwent optimization to individualize hip flexion and extension assistance, followed by a validation comparing optimized assistance (OPT) to biological hip moment-based assistance (BIO), no assistance (No-Assist), and no exoskeleton (No-Exo) conditions.

OPT reduced metabolic cost by 4.5% compared to No-Exo, 11.44% compared to No-Assist, and 5.02% compared to BIO, demonstrating the effectiveness of the optimization approach. Statistical analysis revealed distinct characteristics in optimal assistance timing and magnitude that deviated systematically from biological hip moment patterns. Compared to BIO, OPT exhibited later peak flexion timing (76.4 $\pm$ 3.7% vs 65.0%), shorter flexion duration (29.2 $\pm$ 3.6% vs 40.0%), later peak extension timing (26.7 $\pm$ 3.8% vs 20.0% of gait cycle), and higher peak flexion magnitude (11.1 $\pm$ 1.5 Nm vs 10.0 Nm). While individual optimal assistance profiles varied across participants, comparison between individually optimized parameters and the best subject-independent parameters identified through post-hoc analysis showed consistency. On average, metabolic rate convergence was achieved after 18 iterations, while most exoskeleton control parameters did not reach our convergence criteria within 20 iterations.

These findings demonstrate that human-in-the-loop optimization can effectively identify task-specific assistance patterns for stair climbing, while the consistency between individual and subject-independent parameters suggests the potential for developing generalized assistance strategies. The systematic differences between optimized and biological moment-based assistance underscore the fundamental distinctions between biological torque-based control and optimal control for exoskeleton assistance.