Related Experiment Video
Updated: May 22, 2025

Sandy Soil Improvement through Microbially Induced Calcite Precipitation MICP by Immersion
Published on: September 12, 2019
Experimental Study on the Compression Characteristics of Sand-Silt-Clay Mixtures
Tao Li1,2,3, Jixiao Li1,2,3, Bingyang Li4
1Key Laboratory of Safety Control of Bridge Engineering, Ministry of Education, Changsha University of Science & Technology, Changsha 410114, China.
Abstract:
In order to investigate the influence of the coexistence of clay and silt on the compression characteristics of sand, one-dimensional compression consolidation tests were carried out on reconstituted saturated sand-silt-clay mixtures with a constant initial void ratio, and the effects of fines content (FC) and clay-silt ratio (CS) on the compression characteristics of mixed soils were studied. The mechanism of the experimental results was additionally explained from a microscopic perspective. The test results show that: the compressibility of mixed soil increased with the increase in FC; the compressibility change rule of mixed soils with different CS is consistent under the same FC; the influence of CS on the e-lgp (the void ratio (e) versus logarithm of the pressure (p)) curve of mixed soil is inconsistent when FC is different: when FC = 3%, the compressibility of mixed soil decreased with the increase in CS; when FC = 7% and 10%, the compressibility of mixed soil gradually increased with the increase in CS; when FC = 5%, the compressibility of mixed soil did not show an obvious changing law with the increase in CS, and the compressibility of the specimen with FC = 5%-CS = 1 (FC = 5%, CS = 1) was the largest; when CS was same, the difference between e-lgp curves of mixed soil with different FC increased with the increase in CS. The compression model of sand-silt-clay mixtures was established, which can consider the effects of FC and CS. The reliability and applicability of the proposed model were verified by combining the experimental results of this paper and the test data of sand-clay mixture and sand-silt mixture in other literature.
More Related Videos
05:36Production and Analysis of Sporosarcina pasteurii Biocement Bricks Using Custom 3D-Printed Molds for Unconfined Compression Tests
Published on: March 7, 2025
09:00Visualization of Failure and the Associated Grain-Scale Mechanical Behavior of Granular Soils under Shear using Synchrotron X-Ray Micro-Tomography
Published on: September 29, 2019
Related Concept Videos
Strength of Cement
For compressive strength tests, ASTM C 109-05 standards prescribe a cement-sand mix ratio of 1:2.75 and a water/cement ratio of 0.485 for making 2-inch cubes. These cubes are mixed, cast, and cured in saturated lime water at 23°C until testing. Flexural strength testing, outlined in...
Design Example: Aggregate Gradation
The grading, or particle-size distribution, of sand is determined using sieve analysis, with standard sizes ranging from 150 μm to 10 mm (ASTM No. 100 sieve to 3⁄8 in. sieve). Sand is...
Deleterious Substances in Aggregate
Another type of impurity is clay and fine material that...
Slump Test
Concrete is poured into the mold in three layers to conduct the test. Each layer is compacted 25 times with a steel tamping rod, which has a five-eighths-inch diameter and a rounded end, to ensure even distribution and eliminate...
Moisture Content and Bulking of Aggregate
When aggregates are exposed to rain or sit in stockpiles, they absorb moisture, which must be...
Design Example: Managing Concrete Workability