Related Experiment Video
Updated: May 22, 2025

High-Resolution Neutron Spectroscopy to Study Picosecond-Nanosecond Dynamics of Proteins and Hydration Water
Published on: April 28, 2022
Using neutrons to ascertain the impact of deposition temperature on amorphous solid water
Zachary Amato1,2, Thomas F Headen1, Sabrina Gärtner1,2
1ISIS Facility, Rutherford Appleton Laboratory, Harwell Oxford, Didcot, Oxon OX11 0QX, UK. zachary.amato@stfc.ac.uk.
Abstract:
Amorphous solid water (ASW), formed via vapour deposition under low temperature and pressure conditions, has been the focus of physical- and astro-chemists for some time as it represents the most likely formation process for interstellar ices. The porous structure of ASW has been found to be significantly impacted by deposition conditions, with little literature on the specific impacts of deposition temperature. This work utilises total neutron scattering (TNS) and small angle neutron scattering (SANS) to provide direct experimental evidence that deposition temperature does indeed have a significant impact on the structure of grown ASW. At low deposition temperatures, the ASW structure is highly porous and seemingly in the form of nanoporous islands/grains with voids between them - with these two populations of pores making up the total porosity. With increasing deposition temperatures, the nanopores in the islands become smaller until they are no longer present at temperatures above 80 K, whereby the voids start to dominate. Therefore, even at higher deposition temperatures, there is still porosity present from void volume, rather than being a fully compact ice.
Related Concept Videos
Atomic Spectroscopy: Effects of Temperature
At thermal equilibrium, the relative populations of excited and ground state atoms can be estimated using the Maxwell–Boltzmann distribution. For example, an increase in temperature...
Nuclear Fission
States of Water
Water freezes when the intermolecular forces are greater than the kinetic energy. Unlike most other substances, water is less dense in its solid state than in its liquid state. This is because each water molecule can form...
Heating and Cooling Curves
For instance, the addition of heat raises the temperature of a solid; the amount of heat absorbed depends on the heat capacity of the solid (q = mcsolidΔT). According to thermochemistry, the relation between the amount of heat absorbed or released by a substance, q, and its...
Phase Transitions: Melting and Freezing
Classifying Matter by State

