Related Experiment Video
Updated: May 22, 2025

A Uniaxial Compression Experiment with CO2-Bearing Coal Using a Visualized and Constant-Volume Gas-Solid Coupling Test System
Published on: June 12, 2019
The effect of modified polymer on the change rule of physical properties of different gradation coal gangue
Zhilong Sun1, Xiaozhan Wang1, Jianying Yang2,3,4
1School of Soil and Water Conservation, Beijing Forestry University, Beijing, 100083, China.
Abstract:
In this study, in order to improve the water retention of coal gangue matrix and accelerate the recovery of frozen soil layer in mining area, three different particle size gradations of coal gangue and modified polymer SAP (0.0, 0.1, 0.2, 0.3, 0.4%) were compounded and reconstructed. Based on the indoor soil column model, the change rule of SAP on the physical properties of coal gangue with different gradations is clarified. The results show that SAP can promote the reconstruction of coal gangue matrix. When the mass fraction of SAP is constant, the partial soil gradation reduces the bulk density, and improves the total porosity, capillary porosity and capillary water holding capacity. The inhibition degree of SAP on capillary water migration was different. The sand, soil and viscosity gradations without SAP reached the design height at 1340, 1380 and 1470 min, respectively. When SAP was 0.0% ~ 0.4%, the higher the dosage, the longer the action time. After continuous measurement for 6 days under natural ventilation, SAP was 0.3%. The partial soil gradation had strong water retention performance and could effectively inhibit water loss. With the increase of time, the water loss was the slowest. It is recommended that the preferred SAP mass fraction is 0.3%, the gradation is partial soil, and the bulk density is 1.30 g/cm3, which can provide suitable water and gas conditions for vegetation growth.
More Related Videos
Related Concept Videos
Pozzolans
Fly ash is...
Polymer Classification: Architecture
Molecular Weight of Step-Growth Polymers
As the step-growth polymerization involves step-wise condensation of monomers, the molecular weight also builds up eventually. Consequently, high molecular weight polymers are obtained at the late stages of the polymerization, where 99% of monomers have been consumed.
The extent of the...
Deleterious Substances in Aggregate
Another type of impurity is clay and fine material that...
Abrasion Resistance of Concrete
One such test is the revolving disc test, where three plates...
Factors Affecting Workability

