Related Experiment Video
Updated: May 21, 2025

The Preparation of Electrohydrodynamic Bridges from Polar Dielectric Liquids
Published on: September 30, 2014
Pressure-induced structural and dielectric changes in liquid water at room temperature
Yizhi Song1, Xifan Wu1,2
1Department of Physics, Temple University, Philadelphia, Pennsylvania 19122, USA.
Abstract:
Understanding the pressure-dependent dielectric properties of water is crucial for a wide range of scientific and practical applications. In this study, we employ a deep neural network trained on density functional theory data to investigate the dielectric properties of liquid water at room temperature across a pressure range of 0.1-1000 MPa. We observe a nonlinear increase in the static dielectric constant ɛ0 with increasing pressure, a trend that is qualitatively consistent with experimental observations. This increase in ɛ0 is primarily attributed to the increase in water density under compression, which enhances collective dipole fluctuations within the hydrogen-bonding network as well as the dielectric response. Despite the increase in ɛ0, our results reveal a decrease in the Kirkwood correlation factor GK with increasing pressure. This decrease in GK is attributed to pressure-induced structural distortions in the hydrogen-bonding network, which weaken dipolar correlations by disrupting the ideal tetrahedral arrangement of water molecules.
Related Concept Videos
States of Water
Water freezes when the intermolecular forces are greater than the kinetic energy. Unlike most other substances, water is less dense in its solid state than in its liquid state. This is because each water molecule can form...
Phase Diagram
Phase Diagrams
Heating and Cooling Curves
For instance, the addition of heat raises the temperature of a solid; the amount of heat absorbed depends on the heat capacity of the solid (q = mcsolidÎT). According to thermochemistry, the relation between the amount of heat absorbed or released by a substance, q,...
Phase Transitions
Phase Changes
A substance melts or freezes at a temperature called its melting point and boils or condenses at its boiling point. These temperatures depend on pressure. High pressure favors the denser form of the substance, so typically, high pressure...

