Reproducibility of smooth muscle mechanical properties in consecutive stretch and activation protocols

Mechanical organ models are crucial for understanding organ function and clinical applications. These models rely on input data regarding smooth muscle properties, typically gathered from experiments involving stimulations at different muscle lengths. However, reproducibility of these experimental results is a major challenge due to rapid changes in active and passive smooth muscle properties during the measurement period. Usually, preconditioning of the tissue is employed to ensure reproducible behavior in subsequent experiments, but this process itself alters the tissue's mechanical properties. To address this issue, three protocols (P1, P2, P3) without preconditioning were developed and compared to preserve the initial mechanical properties of smooth muscle tissue. Each protocol included five repetitive experimental cycles with stimulations at a long muscle length, varying in the number of stimulations at a short muscle length (P1: 0, P2: 1, P3: 2 stimulations). Results showed that P2 and P3 successfully reproduced the initial active force at a long length over five cycles, but failed to maintain the initial passive forces. Conversely, P1 was most effective in maintaining constant passive forces over the cycles. These findings are supported by existing adaptation models. Active force changes are primarily due to the addition or removal of contractile units in the contractile apparatus, while passive force changes mainly result from actin polymerization induced by contractions, leading to cytoskeletal stiffening. This study introduces a new method for obtaining reproducible smooth muscle parameters, offering a foundation for future research to replicate the mechanical properties of smooth muscle tissue without preconditioning.