Related Experiment Video

Updated: Jun 10, 2026

Measuring Motor Coordination in Mice
10:07

Measuring Motor Coordination in Mice

Published on: May 29, 2013

Navigating Real-World Obstacles: Comparisons to the Traditional Dowel Rod

Ashlyn M Jendro1, Tiphanie E Raffegeau2, Abigail C Schmitt1

  • 1Department of Health, Human Performance, and Recreation, University of Arkansas, Fayetteville, AR, USA.

PubMed

Related Concept Videos

Dot Product: Problem Solving01:21

Dot Product: Problem Solving

The dot product is a powerful tool in problem-solving involving vectors, given that the dot product of two vectors is the product of their magnitudes and the cosine of the angle between them measured anti-clockwise. Solving problems involving the dot product requires understanding its properties and developing a step-by-step process to solve them. Here are the main steps to follow when solving any general problem involving the dot product:
Identify the problem: Start by reading the problem and...
334
Method of Joints: Problem Solving II01:30

Method of Joints: Problem Solving II

Consider a truss structure with frictionless joints fixed to a wall and roller support. If a force of 150 N is applied to joint A, the forces in each member of the truss can be determined using the method of joints.
479
Bearings: Problem Solving01:24

Bearings: Problem Solving

Understanding the calculations and concepts related to double-collar bearings is essential for engineers and designers to optimize the performance of these components in various applications. By analyzing the bearing under different conditions, one can ensure that it can withstand the forces and moments experienced during operation. This knowledge enables better decision-making when designing and selecting bearings for specific purposes and configurations. Consider a double-collar bearing with...
259
Deformation of Member under Multiple Loadings01:11

Deformation of Member under Multiple Loadings

When a rod is made of different materials or has various cross-sections, it must be divided into parts that meet the necessary conditions for determining the deformation. These parts are each characterized by their internal force, cross-sectional area, length, and modulus of elasticity. These parameters are then used to compute the deformation of the entire rod.
In the case of a member with a variable cross-section, the strain is not constant but depends on the position. The deformation of an...
141
Temperature Dependent Deformation01:12

Temperature Dependent Deformation

In a nonhomogeneous rod made up of steel and brass, restrained at both ends and subjected to a temperature change, several steps are involved in calculating the stress and compressive load. Due to the problem's static indeterminacy, one end support is disconnected, allowing the rod to experience the temperature change freely. Next, an unknown force is applied at the free end, triggering deformations in the rod's steel and brass portions. These deformations are then calculated and added...
134
Design Example: Measuring Distance Between Two Points with Obstructions01:10

Design Example: Measuring Distance Between Two Points with Obstructions

When measuring distances in areas with physical obstructions, such as a lake in a field, surveyors must employ techniques to calculate accurate lengths without direct line measurements. One effective method is the offset technique, which allows for precise distance estimation over inaccessible stretches.In this scenario, a surveyor must measure a side of an area that crosses a lake. Since the measuring tape cannot span the lake, the surveyor begins by establishing a baseline that aligns with...
21