Effect of Oxide Systems on Purity of Tool Steels Fabricated by Electro Slag Remelting

The purity of a steel is an important factor influencing the quality of the final products. Therefore, it is important to optimize the existing and develop new steelmaking technologies that affect the resulting purity. Electro slag remelting is a technology of tertiary metallurgy, which can advantageously be used to fabricate high quality steels. The study presents selected theoretical aspects of oxide systems and their specific influences on effectiveness of the electro slag remelting technology. The aim of this work was to experimentally analyze the purity of a tool steel fabricated by electro slag remelting using two different oxide systems (fused slags). The core of the study is the determination of the overall presence of elements in the steels, a thorough investigation of the presence of (not only) oxide-based inclusions within the investigated tool steel, and a detailed analysis of their chemical composition, including the size of these non-metallic inclusions, using energy dispersive X-ray (EDX) on the scanning electron microscope (SEM). Last but not least, the determination of the modification of the occurring non-metallic inclusions and verification of the experimentally acquired results as well as the calculation of the liquid and solid temperature and the calculation of the viscosity of the slags using the FactSage calculation software was performed. The results showed that the used slag influenced especially the occurrence of Mg and Al-based oxide inclusions. The CaS-type inclusions were present within all of the examined samples. The slag type influenced not only the typical morphology and size of the inclusions (especially of the CaS type), but also the tendency of the steel to exhibit localized corrosion when exposed to the ambient environment. This research can contribute to a better understanding of the effect of oxidation systems on the resulting purity and properties of ESR steels, thereby advancing the production of tool steels with higher quality and performance requirements.