Related Experiment Video

Updated: May 15, 2025

A Wind Tunnel for Odor Mediated Insect Behavioural Assays
05:25

A Wind Tunnel for Odor Mediated Insect Behavioural Assays

Published on: November 30, 2018

11.6K

Current status and prospects of computer vision-based attitude and deformation measurement applications in wind

Xiang Xiangyi1, Wang Shuai2, Cheng Xu1

  • 1School of Mechanical Engineering, Beijing Institute of Technology, Beijing, 100081, China.

Scientific Reports
|April 8, 2025
PubMed

Keywords:
Computer visionData fusionDeep learningDeformation measurementModel attitudePose estimationTest of wind tunnel

More Related Videos

Three-dimensional Particle Tracking Velocimetry for Turbulence Applications: Case of a Jet Flow13:02

Three-dimensional Particle Tracking Velocimetry for Turbulence Applications: Case of a Jet Flow

Published on: February 27, 2016

12.1K
Experimental Investigation of the Flow Structure over a Delta Wing Via Flow Visualization Methods09:17

Experimental Investigation of the Flow Structure over a Delta Wing Via Flow Visualization Methods

Published on: April 23, 2018

10.5K

Related Concept Videos

Deformation in a Circular Shaft01:10

Deformation in a Circular Shaft

One of the distinctive characteristics of circular shafts is their ability to maintain their cross-sectional integrity under torsion. In other words, each cross-section continues to exist as a flat, unaltered entity, simply rotating like a solid, rigid slab. To understand the distribution of shearing stress within such a shaft, consider a cylindrical section inside this circular shaft. This section has a length of L and a radius of R, with one end fixed. The radius of the cylindrical section is...
251
Temperature Dependent Deformation01:12

Temperature Dependent Deformation

In a nonhomogeneous rod made up of steel and brass, restrained at both ends and subjected to a temperature change, several steps are involved in calculating the stress and compressive load. Due to the problem's static indeterminacy, one end support is disconnected, allowing the rod to experience the temperature change freely. Next, an unknown force is applied at the free end, triggering deformations in the rod's steel and brass portions. These deformations are then calculated and added...
132
Measurements of Strain01:27

Measurements of Strain

Strain quantifies the deformation of a material under force, typically measured as normal strain, which represents the change in length when compared with the original length. Electrical strain gauges are used for enhanced accuracy. These devices consist of a conductive wire mounted on a paper backing that adheres to the material's surface. These gauges operate on the piezoresistive effect, where the wire's electrical resistance changes in response to mechanical deformation. The strain...
173
Deformation of a Beam under Transverse Loading01:15

Deformation of a Beam under Transverse Loading

Understanding beam deflection, particularly for indeterminate beams with overhanging segments and multiple concentrated loads, is crucial for ensuring structural integrity and functionality. The process begins with constructing an accurate free-body diagram, which helps identify the forces and moments acting on the beam. This diagram is vital for visualizing how bending moments vary along the beam's length, influencing its curvature.
The insights from the bending moment diagram extend to...
224
Wind Turbine Machine Models01:24

Wind Turbine Machine Models

In the growing field of wind energy, incorporating wind turbine models into transient stability analysis is essential. Induction and synchronous machines are the primary models used, with induction machines being prevalent due to their simplicity and reliability.
Induction machines interact through the rotating magnetic field generated by the stator and the rotor. The key parameter is slip, which is the difference between synchronous speed and rotor speed relative to synchronous speed. Slip is...
91