Uncovering the influence of nitridation on the dislocation density at atomistic scale in III-Nitrides MOCVD/MOVPE...

The impact of NH₃ pre-flow duration on the strain development of AlN and its alloy buffer layers, as well as GaN layers, was reproduced through atomistic simulation. The reported method provides access to information that is not obvious from the raw data alone. The growth morphology of AlN utilizing pre-nitridated silicon substrates was analyzed with respect to the mechanisms of defect formation in each deposited monolayer. This report presents two distinct case studies concerning the epitaxy of the III-nitrides. In the first case study, the crystalline quality of AlN deposited on silicon substrates with NH₃ pre-flow durations of 0 s and 30 s was compared. The growth rates of the samples were aligned with those from previous simulation studies published by our group. It was noted that the defect density extracted from the sample with a 30-second NH₃ pre-flow was lower than that of the sample with a 0-second pre-flow. The results obtained from this preliminary case study led to a repetition of the multistep hetero-epitaxy experiment, previously reported by Kadir et al., with modifications to the NH₃ pre-flow duration on the silicon substrate in the subsequent case study. The epitaxial growth of GaN on AlN and three-step graded Al_xGa_1-xN (where x = 0.8, 0.5, and 0.2) strain relief layers was simulated at the atomistic scale using the MOCVD process over silicon (111) substrates, with variations in NH₃ pre-flow times. The strain induced by lattice mismatch between the silicon substrate (both without and with NH₃ pre-flow) and the various buffer layers was examined in terms of dislocation density extracted layer-by-layer. The effect of NH₃ pre-flow time on the generation of threading dislocation density (TDD) in each monolayer of the AlN and AlGaN buffer layers was analyzed. It was determined that the duration of NH₃ pre-flow significantly influences the morphology and quality of each deposited monolayer justifies the experimental observations. A higher likelihood of amorphous SiN_x formation was observed with no and shorter NH₃ pre-flow times. The lowest TDDs across all strain relief layers were measured at approximately ~ 10¹⁰ cm^- 2. The dislocations generated in the initial buffer layer (AlN) were identified as contributing to the TDD in the subsequent layers. Furthermore, it was noted that the sample lacking an intentional nitridation step displayed a higher TDD and vacancy density compared to those with optimal nitridation.