Related Experiment Video
Updated: May 13, 2025

A Uniaxial Compression Experiment with CO2-Bearing Coal Using a Visualized and Constant-Volume Gas-Solid Coupling Test System
Published on: June 12, 2019
A novel experimental study on impact tendency of real time borehole coal samples under lateral constrained
Ji Ma1,2, Dongsheng Liu3, Ming Yang3
1Hubei Key Laboratory for Efficient Utilization and Agglomeration of Metallurgic Mineral Resources, Wuhan, 430081, China. showsma@hpu.edu.cn.
Abstract:
The impact tendency of coal is a necessary condition for the occurrence of pressure bumping and a measure of the degree of damage. Through the combination of self-made lateral restraint device and high-speed camera, the variation law and failure mode of burst tendency index of coal samples under real-time drilling and pressure relief of lateral restraint under different loads were studied. The results show that: (1) With the increase of real-time drilling load under lateral constraints, the burst tendency index of coal samples changes. (2) The failure order of coal samples is as follows: the corner coal flakes peel off and pulverized coal is sprayed out, cracks and deformations are generated around the borehole, and finally the coal flakes peel off and the cracks penetrate to cause large-area damage of the coal samples. At the same time, the internal energy of the coal samples is released through borehole, which significantly reduces the damage of the coal samples. (3) The lateral restraint device makes the coal samples always in a stable state before and after drilling, resulting in the weakening effect of the burst tendency of the coal sample is not significant, and the pressure relief effect is not obvious. The research results can provide new ideas and methods for drilling and pressure relief test, and also provide basis and guidance for the prevention of pressure bumping in coal mines.
Related Concept Videos
Behavior of Concrete Under Compressive Load
As the concrete specimen fractures under...
Dynamic Modulus of Elasticity of Concrete
The sonic test is a common method to determine the dynamic modulus. In this test, a concrete beam, sized either 6 x 6 x 30 inches or 4 x 4 x 20 inches, is clamped at its center. Vibrations are initiated at one end of the beam by an electromagnetic exciter unit powered by...
Slump Test
Concrete is poured into the mold in three layers to conduct the test. Each layer is compacted 25 times with a steel tamping rod, which has a five-eighths-inch diameter and a rounded end, to ensure even distribution and eliminate...
Mechanical Characteristics of Steel
The tension test is fundamental for determining tensile strength. In this test, a steel specimen is stretched using a gripping device until it breaks. The data collected during this test are used...
Impact Strength of Concrete
Abrasion Resistance of Concrete
One such test is the revolving disc test, where three plates...

