Related Experiment Video
Updated: Apr 11, 2026

Dynamic Pore-scale Reservoir-condition Imaging of Reaction in Carbonates Using Synchrotron Fast Tomography
Published on: February 21, 2017
Characteristics and controlling factors of seismic site response at a crystalline bedrock site based on quality
Naoki Nishizaka1,2, Hiroaki Sato3, Takeshi Tsuji4
1Civil & Architectural Engineering Department, Shikoku Electric Power Co., Inc., 2-5, Marunouchi, Takamastu, 760-8573, Japan. nishizaka14981@yonden.co.jp.
Abstract:
This study evaluated epistemic uncertainty in shear-wave velocity (Vs) profiles and variability in shear-wave quality factor (Qs) profiles across broadband frequencies to investigate characteristics and controlling factors of seismic site response at a crystalline bedrock site. This study utilized deep borehole data down to the seismological bedrock at a depth of 2000 m. Multiple invasive measurements were conducted to estimate the Vs profiles. Three-component seismometers were installed at depths of 5, 160, 500, and 2000 m for Qs profiling. A logic tree with 128 analysis patterns was employed to capture the frequency-dependent percentiles of the amplification factor (AF) and the Qs parameter through spectral ratio Qs inversions. AFs from depths of 2000 m to 5 m showed the attenuation effect was dominant in the frequency range above 1 Hz. Sensitivity analysis revealed the dominant effects of the Qs profile below 2 Hz and above 15 Hz and the significant effects of the Vs profile at 2-15 Hz. The median AF curves were robust due to multiple invasive measurements and constraints from reliable seismic records. Local site responses captured from the 2000- m borehole station are expected to contribute to seismic hazard assessments as a reference of crystalline bedrock sites.
Related Concept Videos
Factors Affecting Workability
Dynamic Modulus of Elasticity of Concrete
The sonic test is a common method to determine the dynamic modulus. In this test, a concrete beam, sized either 6 x 6 x 30 inches or 4 x 4 x 20 inches, is clamped at its center. Vibrations are initiated at one end of the beam by an electromagnetic exciter unit powered by a...
Factors Affecting Creep
Further, the water/cement ratio is critical, as a lower ratio increases concrete strength, thus reducing creep. The strength of the...

