Related Experiment Video
Updated: Jun 21, 2026

Reverse Total Shoulder Arthroplasty
Published on: July 5, 2011
Is it enough to utilize a single anchor for repair of rotator cuff tears ≤ 3 * 3 cm²?
Ala' Hawa1, Alexander Tham2, James Bilbrough2
1Department of Surgery, Orthopedics Division, Faculty of Medicine, Yarmouk University, Irbid, Jordan.
Background:
Biomechanical studies showed that increasing number of anchors could improve the repair strength of the repaired cuff at time zero.
Purpose:
The aim of this study was to determine if utilizing only a single anchor for a cuff tear repair is sufficient or otherwise to give a similar retear rate and clinical outcome as multiple anchors in a matched group of patients.
Study Design:
Cohort study; Level of evidence, 3.
Methods:
Retrospective analysis of 346 matched consecutive patients (single anchor group, n = 173; multiple anchors group, n = 173) who had cuff tears ≤ 3*3 cm² (mediolateral * anteroposterior diameters) repaired by a single senior surgeon. Ultrasound was used to evaluate the integrity of repair 6 months post-surgery. Patient and surgeon reported outcomes were used to evaluate the clinical outcome of the method used for repair.
Results:
6 months post-surgery; the retear rate for cuff tears ≤ 1*1 cm², tears ≤ 1 cm in mediolateral diameter and > 1 cm in anteroposterior diameter and tears > 1 cm in mediolateral diameter and ≤ 1 cm in anteroposterior diameter was similar in single and multiple anchors groups (4.8%) (3.3%) (P = 1.00), (10.8%) (7.9%) (P = 0.71) and (0%) (0%) respectively. Retear rate for cuff tears > 1*1 cm² was significantly higher in single anchor group (25.4%) compared to multiple anchors groups (10.9%) (P < 0.05). Operative time was significantly lower in single anchor group (14 minutes) compared to multiple anchors group (20 minutes) (P < 0.05) only for cuff tears ≤ 1*1 cm².
Conclusion:
6-months post-surgery; there was no significant difference in retear rate or clinical outcome between patients with tears ≤ 3*3 cm² (mediolateral * anteroposterior diameters) who had their cuff tears repaired using a single anchor compared to those who had their cuff tears repaired using multiple anchors unless both the mediolateral and anteroposterior diameters of the tear were > 1 cm, for which the utilization of multiple anchors showed a significantly lower retear rate at 6 months post-surgery. Operative time was significantly shorter only when a single anchor was used for repair of tears ≤ 1*1 cm².
Related Concept Videos
Bearings: Problem Solving
Deformation in a Circular Shaft
Plastic Deformation in Circular Shafts
Transmission Shafts: Problem Solving
Next, use bending moment diagrams for the shaft to...
Microcracking in Concrete
