Microstructure and Mechanical Properties of Toughened Seven-Wire Electrogas Welding

Based on the flexible adjustment of the seven-wire, this study will assemble a new toughened seven-wire which is combined with a common single welding wire and the existing welding wire containing ductile alloy element (Ni element), and the microstructure properties, mechanical properties and toughening mechanism of the welding seams were studied. The results show that the microstructure of the four combinatorial seven-wire welding seams is mainly composed of coarse proeutectoid ferrite (PF) and fine acicular ferrite (AF). Among them, the core of inclusions that induce AF nucleation and growth are mainly composed of Al, Ti, Si, and Mn-based oxides, and the edge of inclusions is mainly composed of Mn and Cu sulfides (MnS, CuS). The addition of Ti compounds further promotes AF nucleation. This is also a reason why the impact toughness of the combinatorial seven-wire W2/W3 welding seams is higher than that of other combinatorial seven-wire welding seams, but the impact toughness of the rich Ni seven-wire can meet the standard requirements of the China Classification Society (CCS). Among the four combinatorial seven-wire welding seams, the proportions of large angle grain boundaries (grain orientation difference ≥ 15°) that improve the ability of materials to prevent brittle fracture are 65.9%, 68.8%, 66.0%, 61.7%, respectively, that is, the larger proportion of large angle grain boundaries in combinatorial seven-wire W2 welding seams (Ni content is 0.0897%) is one of the reasons for the higher impact toughness of the welding seams. With the increase of Ni content in the welding seam, the AF content first increased and then decreased, the yield strength and tensile strength increased, and the elongation and section shrinkage first increased and then decreased. When the combinatorial seven-wire W2/W3 was used, the welding seam plasticity was the best.