Related Experiment Video
Updated: May 10, 2025

Comparison of Kinetic Characteristics of Footwork during Stroke in Table Tennis: Cross-Step and Chasse Step
Published on: June 16, 2021
Comparison of External and Internal Training Loads in Elite Junior Male Tennis Players During Offensive vs. Defensive
Péter János Tóth1, Gabriella Trzaskoma-Bicsérdy2, Łukasz Trzaskoma3
1Department of Sport Games, Hungarian University of Sports Science, 1123 Budapest, Hungary.
Abstract:
The aim of our pilot study was to investigate the effects of offensive and defensive strategy conditions on external and internal training load factors in male tennis players. This study included six elite junior male tennis players (chronological age: 15.7 ± 1.0; body height: 180.7 ± 6.5 cm; body mass: 71.0 ± 10.8 kg) who had to play two simulated matches. Among the external training load variables, running activities were measured with a GPS sensor operating at 10 Hz and a 100 Hz tri-axial piezoelectric linear accelerometer integrated into it; furthermore, tennis shot activities were measured with a tennis racket-mounted smart sensor. Internal training load was measured subjectively using the RPE method. The results show that players scored significantly higher on the PlayerLoad (p = 0.031; r = 0.90) and IMA CoD low right (p = 0.031; r = 0.90) running variables and on the forehand spin (p = 0.031; r = 0.90) and backhand spin (p = 0.031; r = 0.90) when using a defensive strategy. There were no significant differences between the two strategy conditions in all other external and internal training load parameters. The defensive strategy has more acceleration in all three planes of motion, suggesting that conditioning training should be placed in the intermittent endurance capacities for players who predominantly use this strategy.
More Related Videos
Related Concept Videos
Internal and External Forces
Force and Momentum
Stress: General Loading Conditions
The shearing force, possessing potential directionality within the plane of the section, is simplified into two component forces running parallel to the x and y axes....
Stresses under Combined Loadings
The process begins by slicing the tube at critical points and analyzing the internal forces and stress components at these sections, focusing on the centroid. Normal stresses, generated by axial forces and bending moments, are either compressive or tensile and vary across the section from...
Impact Loading
In cases of elastic deformation,...
Internal Loadings in Structural Members: Problem Solving
To illustrate this, let's consider a beam OC of 5 kN, inclined at an angle of 53.13° with the horizontal and supported at both ends. Determine the internal...

