Related Experiment Video
Updated: May 10, 2025

A Uniaxial Compression Experiment with CO2-Bearing Coal Using a Visualized and Constant-Volume Gas-Solid Coupling Test System
Published on: June 12, 2019
Research on blasting technology for thick and hard roof fracturing in isolated island coal mine working face
Wei Huang1,2, Gang Jing3,4,5, Liqiang Ma6,7,8
1Key Laboratory of Xinjiang Coal Resources Green Mining, Ministry of Education, Xinjiang Institute of Engineering, Urumqi, 830023, China.
Abstract:
In order to study the prevention and control technology for hard roof type coal burst in the isolated working face of the Chenjiashan coal mine, the 418 isolated working face was selected as the engineering case study. Based on the different impact danger zones and mining areas, a roof breaking blasting pressure relief technical scheme was proposed. The anti-impact effect was verified through hole peeping and infrared radiation data. The research shows: (1) According to the geological conditions of the 418 working face of the Chenjiashan coal mine, the working face is divided into weak impact hazard areas and moderate impact hazard areas. Targeted roof blasting schemes were proposed for the initial square area of the working face, moderate danger area, weak danger area, initial mining and initial caving area, and the strike area of the working face. (2) On-site borehole data show that after blasting, a large number of fractures and delaminations were formed in the roof, and some fractures further developed into delaminations, with local areas showing crushed zones. This proves the formation of a "buffer zone" in the roof and floor, achieving pre-cracking of the thick and hard roof, full development of fractures, significant reduction in stress concentration, and the roof blasting can achieve good pressure relief effect. (3) The temperature monitoring near the blasting point and the infrared radiation temperature shows that within an hour after the implementation of the roof blasting, the coal mass at the breaking position experienced a process of heating up and then cooling down, with the temperature at the monitoring point rising by 0.5-0.7 °C. After the implementation of the roof blasting, the key layer above the working face was destroyed, and the stress was released and transmitted to the corresponding area of the coal mass, the stress of the coal increased, and the infrared radiation temperature increased, proving that the blasting pressure relief achieved the expected effect.
More Related Videos
10:36Stress Distribution During Cold Compression of Rocks and Mineral Aggregates Using Synchrotron-based X-Ray Diffraction
Published on: May 20, 2018
10:06Microfluidic Fabrication Techniques for High-Pressure Testing of Microscale Supercritical CO2 Foam Transport in Fractured Unconventional Reservoirs
Published on: July 2, 2020
Related Concept Videos
Quarrying of Stone
One common method involves using a diamond belt saw to cut large blocks from the quarry face. These blocks can be about 50 feet long and 12 feet high. After the initial vertical cut, drilling is performed at the base of the...
Flail Chest-II
Assessment:
1. Clinical Evaluation:
History:
Abrasion Resistance of Concrete
One such test is the revolving disc test, where three plates...
Reinforced Brick Masonry
To fortify brick walls...
Brick Cutting Techniques
Cut bricks are categorized by size. Bricks cut to half their original length are called half-bats, while those cut to three-fourths their length are known as three-fourth bats.
Special types of...
Shotcrete