Exploring the Use of 5 Different Yo-Yo Tests in Evaluating V ̇ O 2 max $$ \dot{\mathrm{V}}{\mathrm{O}}_{2\max } $$

Zhiyuan Tan1, Carlo Castagna2,3,4, Peter Krustrup4,5,6

  • 1Faculty of Sport and Physical Education, University of Belgrade, Belgrade, Serbia.

Related Concept Videos

Multiple Comparison Tests01:13

Multiple Comparison Tests

Multiple comparison test, abbreviated as MCT, is a post hoc analysis generally performed after comparing multiple samples with one or more tests. An MCT will help identify a significantly different sample among multiple samples or a factor among multiple factors.
It would be easy to compare two samples using a significance alpha level of 0.05. In other words, there is only one sample pair to be compared. However, it would be difficult to identify a significantly different sample if the number...
3.8K
Comparing Experimental Results: Student's t-Test01:09

Comparing Experimental Results: Student's t-Test

The t-test is a statistical method used to compare the sample mean with a population mean or compare two means from two data sets. The test statistic is calculated from the standard deviation, mean, and number of measurements in the data set at a selected confidence interval and then compared to a table of critical values at this confidence level. If the test statistic is smaller than the critical value, the null hypothesis is accepted. In this case, we state that the difference between the...
1.4K
McNemar's Test01:23

McNemar's Test

McNemar's Test is a nonparametric statistical test used to determine if there is a significant difference in proportions between two related groups when the outcome is binary (e.g., yes/no, success/failure). It is beneficial when we have paired data, such as pre-test/post-test designs, where the same subjects are measured under two different conditions. The test is named after the statistician Quinn McNemar, who introduced it in 1947. It is commonly used in situations where subjects are...
88
Complementation Tests00:49

Complementation Tests

A complementation test is a simple cross to identify whether the two mutations are located on the same gene or different genes. It was first performed by Edward Lewis in the 1940s while working on fruit flies. He developed the test to identify the location and arrangement of different mutations on chromosomes.
Organisms heterozygous for different mutations are crossed pairwise in all combinations. If present on different genes, the mutations can complement each other by providing the missing...
4.8K
Introduction to Test of Independence01:21

Introduction to Test of Independence

In statistics, the term independence means that one can directly obtain the probability of any event involving both variables by multiplying their individual probabilities. Tests of independence are chi-square tests involving the use of a contingency table of observed (data) values.
The test statistic for a test of independence is similar to that of a goodness-of-fit test:
2.1K
Test for Homogeneity01:23

Test for Homogeneity

The goodness–of–fit test can be used to decide whether a population fits a given distribution, but it will not suffice to decide whether two populations follow the same unknown distribution. A different test, called the test for homogeneity, can be used to conclude whether two populations have the same distribution. To calculate the test statistic for a test for homogeneity, follow the same procedure as with the test of independence. The hypotheses for the test for homogeneity can...
1.9K