Study of Properties of Composite Cementitious Materials with Sulfoaluminate Cement and Solid Waste Based on...

The traditional cement compaction process boasts notable advantages such as high strength, durability, and aesthetic appeal. However, compaction forming technology for cement products results in high carbon emissions. Consequently, it is imperative to develop low-carbon strategies for these products. This study investigates the modification of solid waste-based low-carbon sulfoaluminate cementitious material (SSCM) using mineral powder (MP) and steel slag micro powder (SSMP) under compaction forming technology. The results indicate that higher compaction pressure leads to higher early-stage strength, while the later-stage strength is primarily influenced by the degree of hydration. At a compaction pressure of 40 MPa, the one-day compressive strength of the material exceeded 70 MPa, representing a 48.31% increase compared to the control group. Under compaction forming, the hydration reaction rate decreased, but the compaction process significantly reduced porosity. Moreover, higher pressure correlated with a reduction in the proportion of harmful pores. Incorporating 25% MP and 20% SSMP increased the compressive strength by 10.66% to 113.5 MPa. According to orthogonal experimental results, the optimal molding conditions entail a 20% MP content, a 20% SSMP content, and a molding pressure of 40 MPa. The research findings can serve as a theoretical foundation for the widespread application of SSCM and compaction forming technology in practical engineering.