Comparative Study on Strengths of Ready-to-Assemble and Eccentric Furniture Joint

This study compared two groups of furniture joints, i.e., a so-called ready-to-assemble (RTA) plastic biscuit joint from Lamello©, while the second group consists of four types of eccentric joints with beech dowels. L-shaped specimens were prepared with the help of the selected joints and a three-layer particleboard with dimensions of 150 × 150 × 400 mm. These L-shaped specimens were tested for bending moment capacity under compression and under tension. Cam joints with wooden dowels can withstand high stress. If Lamello© Bisco P-15 joints are added to the plastic Clamex P-14 joint, this joint will achieve 13% higher values for bending moment capacity under compression and 22% under tension. During testing, the worst result was achieved by the Tenso P-14 joint. The best values achieved during the testing of bending moment capacity under compression and under tension were for an eccentric joint with the use of a metal-capped bolt and Euro screw. This joint achieved 147% higher values for bending moment capacity under compression than a standard eccentric joint with a euro screw bolt and 213% higher values for bending moment capacity under compression than the Lamello© and Clamex P-14 joints. This study aimed to determine how the joints differ, how they behave during testing, and what deformations occur.