Related Experiment Video
Updated: May 20, 2025

A Method to Test the Efficacy of Handwashing for the Removal of Emerging Infectious Pathogens
Published on: June 7, 2017
Short-term bactericidal properties differ between 2 alcohol-based surgical antiseptic products using the glove-juice
Katrijn D Whisenant1, Holly L Stewart1, Donna Kelly2,3
11Department of Clinical Studies, New Bolton Center, School of Veterinary Medicine, University of Pennsylvania, Philadelphia, PA.
Objective:
To evaluate the efficacy of 2 alcohol-based hand preparations (61% weight/weight ethanol and 1% chlorhexidine gluconate [Avagard; 3M] and 85% weight/weight ethanol [Sterillium; BODE Chemie GmbH]) in reducing bacterial colony count with the glove-juice method. We hypothesized that there would be no difference between hand preparations immediately following or 1 hour after application.
Methods:
A prospective clinical trial was performed with sampling on August 3, 2023. Preliminary CFUs were obtained from both hands of 8 participants via glove-juice sampling from sterile gloves. Participants washed their hands with a neutral soap before the application of any antiseptics. Avagard was applied to the right hand and Sterillium was applied to the left hand by sterile assistants according to the manufacturer's guidelines. Glove-juice samples were taken immediately after application and 1 hour after application. Samples were cultured and evaluated within 48 hours of plating. Log10-reduction CFUs were compared between antiseptics and across time points.
Results:
Results were based on 7 participants due to a missing time point. Both Sterillium and Avagard showed a reduction in CFUs immediately after application. For Avagard, there was a sustained reduction in CFUs at 1 hour after application.
Conclusions:
Both hand preparations were effective antiseptics immediately following application. Avagard was effective at reducing bacterial CFUs 1 hour after application.
Clinical Relevance:
Unless for reapplication, only Avagard should be considered if surgery is expected to be longer than 1 hour or reapplication of Sterillium is recommended.
More Related Videos
Related Concept Videos
Hand hygiene
Hand washing...
Methods of Sterilization II: Chemical Methods
Using chemical sterilization rather than heat to clean out equipment is recommended. It eradicates and removes all bacteria,...
Handwashing II: Pre-procedure and Initial Procedure Steps
The hand washing procedure itself includes the following steps. First, cover cuts, if any, on hands with a waterproof dressing. Cuts and abrasions can become contaminated with bacteria hindering the ability to clean the area thoroughly. In addition, repeated hand washing can worsen an injury. The nails must be short and clean, without nail...
Surface Membrane Barriers
The outer layer of the skin, the epidermis, is a robust barrier comprising layers of closely packed keratinized cells. This dense arrangement prevents microbes from penetrating the body. The periodic shedding of epidermal cells...
Handwashing III: During the Procedure and Post-Procedure Steps
Methods of Sterilization I: Physical Methods
Steam sterilization uses non-toxic, low-cost moist heat in the form of saturated steam under pressure, which is fast, microbicidal, and sporicidal, and quickly warms and penetrates fabrics. Autoclaves, or steam sterilizers, expose each item to direct steam contact for a predetermined time at the necessary...

