Investigating the Evolution of Student Attitudes toward Science in a General Chemistry Course Using Latent Class and

Oluwatobi O Odeleye1, Oluwaseun D Agunbiade1, Adam Garber2

  • 1Department of Chemistry, West Virginia University, Morgantown, West Virginia 26505, United States.

PubMed

Related Concept Videos

Predicting Reaction Outcomes02:24

Predicting Reaction Outcomes

Kinetics describes the rate and path by which a reaction occurs. In contrast, thermodynamics deals with state functions and describes the properties, behavior, and components of a system. It is not concerned with the path taken by the process and cannot address the rate at which a reaction occurs. Although it does provide information about what can happen during a reaction process, it does not describe the detailed steps of what appears on an atomic or a molecular level. On the other hand,...
8.1K
Le Chatelier's Principle: Changing Temperature02:19

Le Chatelier's Principle: Changing Temperature

Consistent with the law of mass action, an equilibrium stressed by a change in concentration will shift to re-establish equilibrium without any change in the value of the equilibrium constant, K. When an equilibrium shifts in response to a temperature change, however, it is re-established with a different relative composition that exhibits a different value for the equilibrium constant.
To understand this phenomenon, consider the elementary reaction:
 
Since this is an elementary reaction,...
28.8K
Comparing Experimental Results: Student's t-Test01:09

Comparing Experimental Results: Student's t-Test

The t-test is a statistical method used to compare the sample mean with a population mean or compare two means from two data sets. The test statistic is calculated from the standard deviation, mean, and number of measurements in the data set at a selected confidence interval and then compared to a table of critical values at this confidence level. If the test statistic is smaller than the critical value, the null hypothesis is accepted. In this case, we state that the difference between the...
1.4K
Classifying Matter by Composition03:35

Classifying Matter by Composition

Matter: Pure Substances and Mixtures
According to its composition, the matter can be classified into two broad categories — pure substances and mixtures. 
A pure substance is a form of matter that has a constant composition throughout with uniform properties. For example, any sample of sucrose has the same composition and same physical properties, such as melting point, color, and sweetness, regardless of the source from which it is isolated. 
A mixture is composed of two or...
70.0K
Inductive Effects on Chemical Shift: Overview01:27

Inductive Effects on Chemical Shift: Overview

The protons in unsubstituted alkanes are strongly shielded with chemical shifts below 1.8 ppm. Methine, methylene, and methyl protons appear at approximately 1.7, 1.2 and 0.7 ppm, while the proton signal from methane appears at 0.23 ppm. An electronegative substituent, such as chlorine, withdraws the electron density from the protons, increasing their chemical shift. Progressive substitution of the hydrogens in methane by chlorine shifts the proton signals increasingly downfield, to 3.05 ppm in...
1.0K
Factors Influencing the Rate of Chemical Reactions01:22

Factors Influencing the Rate of Chemical Reactions

A variety of factors influence the rate of chemical reactions. For a chemical reaction to happen, atoms must collide with enough energy to overcome the repulsion between their electrons. This energy is called activation energy. Factors influencing the rate of reaction either lower the activation energy or increase the likelihood of a successful collision.
Concentration and Pressure:
The more particles present within a given space, the more likely those particles are to bump into one another....
2.7K