LeFood-set: Baseline performance of predicting level of leftovers food dataset in a hospital using MT learning

Yuita Arum Sari1,2, Atsushi Nakazawa1, Yudi Arimba Wani3

  • 1Graduate School of Interdisciplinary Science and Engineering in Health Systems, Okayama University, Kita-Ku, Okayama, Japan.

Plos One
|May 19, 2025
PubMed

Related Concept Videos

Nominal Level of Measurement00:56

Nominal Level of Measurement

The way a set of data is measured is called its level of measurement. Correct statistical procedures depend on a researcher being familiar with levels of measurement. Not every statistical operation can be used with every set of data. For analysis, data are classified into four levels of measurement—nominal, ordinal, interval, and ratio.
The data that cannot be measured but can be grouped into categories fall under the nominal level of measurement. Data that is measured using a nominal...
27.6K
Residuals and Least-Squares Property01:11

Residuals and Least-Squares Property

The vertical distance between the actual value of y and the estimated value of y. In other words, it measures the vertical distance between the actual data point and the predicted point on the line
If the observed data point lies above the line, the residual is positive, and the line underestimates the actual data value for y. If the observed data point lies below the line, the residual is negative, and the line overestimates the actual data value for y.
The process of fitting the best-fit...
7.2K
Quantifying and Rejecting Outliers: The Grubbs Test01:02

Quantifying and Rejecting Outliers: The Grubbs Test

Sometimes, a data set can have a recorded numerical observation that greatly  deviates from the rest of the data. Assuming that the data is normally distributed, a statistical method called the Grubbs test can be used to determine whether the observation is truly an outlier.  To perform a two-tailed Grubbs test, first, calculate the absolute difference between the outlier and the mean. Then, calculate the ratio between this difference and the standard deviation of the sample. This...
1.4K