A Global Thermodynamic-Kinetic Model Capturing the Hallmarks of Liquid-Liquid Phase Separation and Amyloid

Kamal Bhandari1, Yunxiang Sun1, Huayuan Tang1

  • 1Department of Physics and Astronomy, Clemson University, South Carolina, United States.

Abstract

Related Concept Videos

Molecular Comparison of Gases, Liquids, and Solids02:26

Molecular Comparison of Gases, Liquids, and Solids

Particles in a solid are tightly packed together (fixed shape) and often arranged in a regular pattern; in a liquid, they are close together with no regular arrangement (no fixed shape); in a gas, they are far apart with no regular arrangement (no fixed shape). Particles in a solid vibrate about fixed positions (cannot flow) and do not generally move in relation to one another; in a liquid, they move past each other (can flow) but remain in essentially constant contact; in a gas, they move...
40.7K
Phase Transitions: Melting and Freezing02:39

Phase Transitions: Melting and Freezing

Heating a crystalline solid increases the average energy of its atoms, molecules, or ions, and the solid gets hotter. At some point, the added energy becomes large enough to partially overcome the forces holding the molecules or ions of the solid in their fixed positions, and the solid begins the process of transitioning to the liquid state or melting. At this point, the temperature of the solid stops rising, despite the continual input of heat, and it remains constant until all of the solid is...
12.3K
Amyloid Fibrils03:03

Amyloid Fibrils

Amyloid fibrils are aggregates of misfolded proteins.  Under most circumstances, misfolded proteins are either refolded by chaperone proteins or degraded by the proteasome. However, in the case of a mutation or a disease, these proteins can accumulate to form large clusters and often further assemble to form elongated fibers, called fibrils. 
Amyloid deposits were observed as early as 1639 in the liver and the spleen.   In 1854, Rudolph Virchow performed iodine staining,...
9.3K
Comparing Intermolecular Forces: Melting Point, Boiling Point, and Miscibility02:34

Comparing Intermolecular Forces: Melting Point, Boiling Point, and Miscibility

Intermolecular forces are attractive forces that exist between molecules. They dictate several bulk properties, such as melting points, boiling points, and solubilities (miscibilities) of substances. Molar mass, molecular shape, and polarity affect the strength of different intermolecular forces, which influence the magnitude of physical properties across a family of molecules.
Temporary attractive forces like dispersion are present in all molecules, whether they are polar or nonpolar. They...
44.0K
Entropy and Solvation02:05

Entropy and Solvation

The process of surrounding a solute with solvent is called solvation. It involves evenly distributing the solute within the solvent. The rule of thumb for determining a solvent for a given compound is that like dissolves like. A good solvent has molecular characteristics similar to those of the compound to be dissolved. For example, polar solutions dissolve polar solutes, and apolar solvents dissolve apolar solutes. A polar solvent is a solvent that has a high dielectric constant (ϵ...
7.0K
Chemical and Solubility Equilibria02:21

Chemical and Solubility Equilibria

The free energy change associated with dissolving a solute in a liter of solvent is called the free energy of a solution, ΔGsolution. The overall ΔGsolution is expressed as the balance of ΔGinteraction against the always-favorable free-energy of mixing, ΔGmixing. Solution formation is favorable if  ΔGsolution is less than zero, whereas it is unfavorable if ΔGsolution is greater than zero. In short, for a solution to form and complete dissolution to take place,...
4.1K